Thread Tools
Old Aug 03, 2011, 04:11 PM
RcToysFinder is offline
Find More Posts by RcToysFinder
Registered User
RcToysFinder's Avatar
Help!

Soldering Esc`s for Quadro/Hexa/Octo..


Hi together

I need your help. Please let me know how you solder the ecs`s together.
If you have 4 or more Esc`s it is very tricky. Please show me how you do this solder job or any other options

Thx for your answers
Last edited by RcToysFinder; Aug 03, 2011 at 04:36 PM.
Sign up now
to remove ads between posts
Old Aug 03, 2011, 05:23 PM
kinderkram is offline
Find More Posts by kinderkram
OS Sponsor
kinderkram's Avatar
Quote:
Originally Posted by RcToysFinder View Post
Hi together

I need your help. Please let me know how you solder the ecs`s together.
If you have 4 or more Esc`s it is very tricky. Please show me how you do this solder job or any other options

Thx for your answers
You could go for a power distribution:
http://www.flyduino.com/product_info...er-board.html/
Old Aug 03, 2011, 06:14 PM
Michael64 is offline
Find More Posts by Michael64
Registered User
kinderkram
Do you by chance have any photos of how you connected the wiring this board I ordered two of them and not sure how is the best way to connect the ESC wires and battery leads I know solder but what about connectors any advice what help alot. I have been using Mactadpole setup with the deans and solid 12 ga. copper wire.

Michael64

Michael64
Old Aug 03, 2011, 06:23 PM
iota is offline
Find More Posts by iota
Registered User
iota's Avatar
Some time ago i have done this: see below

But these are tiny Turnigy Plush 6. They are converted to I2C-Control and equipped with Quax-Software

Juergen
Old Aug 04, 2011, 04:56 PM
RcToysFinder is offline
Find More Posts by RcToysFinder
Registered User
RcToysFinder's Avatar
Thx for your answers.
I think i must made two wire rings one with the + and one with - pole.
Then i cut 6 pieces out and solder the esc wires to them.

To kinderkram:
How many amps does this boards can handle ? I will use it for a hexa with 6x 60A on 4S.
Do you know the dimensions ?


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Poll Quad X8, Y6, Hexa, Octo? Rusty's Rev-8 Frame decision daign Multirotor Talk 2 Jul 20, 2011 10:28 PM
Help! Measurements or CAD for MK hexa and octo mounting points for electronics? tabbytabb Multirotor Talk 5 Feb 27, 2011 02:36 PM
Discussion MK Quadro XL or Hexa Ripper78 Multirotor Talk 9 Feb 23, 2011 01:56 PM
Discussion AP Hexa or Octo? What gives you the best stabilisation? Voguna Multirotor Talk 7 Feb 09, 2011 07:35 AM
Discussion "mkTR" Hexa/Octo camera gimbal Photoship One Multirotor Talk 0 May 27, 2010 03:00 PM