New Products Flash Sale
Thread Tools
Old Jul 26, 2011, 07:24 PM
JOHN SCALE BOAT is offline
Find More Posts by JOHN SCALE BOAT
Registered User
JOHN SCALE BOAT's Avatar
New Product

Robot ESC works great in Scale boat with mixing


Bought this ESC and tried it in my boat and it works great! Look at the specs. 6 to 24 volts 12 amps max per channel. Built in selectable lipo on or off. Selectable duel channel operation work as either independent or mixed with another. I selected mixed throttle with rudder. As you move the rudder the inside motor slows and then reverses linearly with rudder stick movement. I use the aileron stick to control the rudders. Could not be happier.... and made in the USA.

http://www.robotmarketplace.com/prod...ER2X12-RC.html
Sign up now
to remove ads between posts
Old Jul 26, 2011, 10:38 PM
ZZ56 is offline
Find More Posts by ZZ56
Nickel Belter
ZZ56's Avatar
I also have this in a boat under construction and though i haven't had open water trials, nothing but good things to say. It's virtually silent, I cannot hear any motor whine as they throttle up.

Also, when you are stationary in mixed mode, swinging the rudder fires up the engines in opposite directions. If my bathtub were circular, i could tell you how that works out.
Old Jul 28, 2011, 02:41 AM
boater_dave is offline
Find More Posts by boater_dave
Big Boats Rule!
boater_dave's Avatar
And they are small and light. I used one in my 1:48 PCF Swift build. My only complaint was when we used it in a bigger, faster, boat. At speed I wish the mixing would be exponentially less as the rudders are better. But for tugs and slower boats they are handy.

Dave
Old Jul 28, 2011, 08:48 AM
patmat2350 is offline
Find More Posts by patmat2350
RingTheBellsThatStillCanR ing
patmat2350's Avatar
Thanks, lots of goodies there.

Here's a good-looking motor for direct driving a big 4" or so prop:
http://www.robotmarketplace.com/prod...-217-2000.html

It has an 8mm shaft, which will require some effort to adapt- most model boats couplers max out at about 6mm.




And another, a little slower:
http://www.robotmarketplace.com/prod...-204-1021.html

Old Jul 28, 2011, 09:00 AM
tghsmith is offline
Find More Posts by tghsmith
Registered User
tghsmith's Avatar
they have a very good selection of switches that plug into your receiver to handle higher volt/amp loads plus dual functions...


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold NEW IN BOX GREAT PLANES Elctro Streak Fiberglass ARF kit with esc, motor folding prop mechengineer03 Aircraft - Electric - Airplanes (FS/W) 1 Jul 23, 2011 07:48 PM
Discussion What brushless airplane esc works well in a boat ? mortonj69 Racing Boats - Electric 1 Jun 03, 2011 07:59 AM
Discussion CHDK- Taking Off\Landing with close Lenss- It Works Great!! guyg Aerial Photography 7 Apr 01, 2011 11:40 AM
Discussion Now with data: Hobbyking SS 25A esc works great it was my fault for not testing first handyfella Power Systems 40 Mar 26, 2011 10:29 AM
Crow mixing on flying wings: works great! surfimp Slope 20 Mar 25, 2005 07:03 PM