Thread Tools
Old Jul 21, 2011, 12:12 PM
lincoln is offline
Find More Posts by lincoln
Registered User
P.S. Or you could make it from something like maple and reuse it.
Sign up now
to remove ads between posts
Old Jul 21, 2011, 12:39 PM
Phil Barnes is offline
Find More Posts by Phil Barnes
Registered User
Yeah. Lots of options out there. To me, the easiest thing is to use the 1/32" spacer and remember to sand that slight bevel on the aft edge of the main wing core. If you want a reusable spacer, well that's what the teflon sheet material does better than anything else that is even imaginable. Have you ever tried to glue anything to teflon? The other important thing to remember is to avoid getting too much epoxy in the hinge line area when doing the pre-facing method. Any excess epoxy will need to be removed by some time consuming method.
Old Jul 21, 2011, 08:47 PM
GaryO is offline
Find More Posts by GaryO
Registered User
I tried some rubber sheeting that I picked up at Home Depot. It's used for waterproofing showers underneath the tile and base.

Works fine, I just wax it up.

Gary


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold 1.5M DLG AG kevlar/disser wing pyrsly Aircraft - Sailplanes (FS/W) 8 May 14, 2011 08:43 PM
Question Where to get 1.7 oz Kevlar in 3/8" - 1/2" strips? veelkie Hand Launch 2 May 02, 2007 11:48 PM