after years of lurking I have decided to make me first scratch build a geebee r3


I have a cnc machine I am going to cut it into a chunk of pink foam to start see how it comes out wish me luck

took longer to find the camera then it did to cut I make this with a 1/4 bit cause thats all I had that will work on foam the foam is easy to sand so I will go cut the other half glue them then sand them down accoring to vetric aspire the cut time is 10.14 seconds

Sweet, sweet, sweet. What is the length of the fuselage?

it is small 11" it is for my parkzone brick my motor fried last night though so whats a no go till monday


I made a mistake on the fuse so I dat to recut but all in all it only took 40 min to cut recut sand and glue

hobby king sent me the wrong motor props so I can not even go brushless on the DSM2 6-channel Ultra Receiver but monday I hope to get the replacement motor have some vids of her flying


I have a question if the fuse is 11" what should the wing size be is there a proper ratio or just what ever I want?


thanks for the comments Rusty-Gunn you were one of the first people I looked at making diy planes and I said one day I hjave too do that took 4 yeas but i am doing it now

I had thought this one would be about 20 to 30 inches long.

This is a test for my cnc make sure it cut it nicely the next one will be 17 " fuse