help my tx for walkera 4f200 got reset . - RC Groups
Jul 11, 2011, 04:04 AM
Registered User
Discussion

# help my tx for walkera 4f200 got reset .

help my tx for walkera 4f200 got reset what do i do https://static.rcgroups.net/forums/i...lies/frown.gif
 Jul 11, 2011, 06:53 AM Registered User
Jul 11, 2011, 09:49 AM
"you'll play to live "

# basic settings for 4F200

First, choose a new slot on TX 2801, name it 4F200.
Begin to put all data shown here to appropriate function. Don't forget to save it before proceding with another input!

-STICK = Mode2
-COMPTB = 2801
-SWASH = 1 servo normal
-MDSET:
* REVERS: channel 1 & 2 reversed. All others are Normal
* GYRHLD: GYROSENS=90%
* DR & EXP: all ELEV, AIL, RUDDER: D/R=100% , EXP= LIN
* CURVES:
THRCURVE: NOR=0 ,1=25%, 2=50%, 3=75%, 4=100%
ST-1: 0=100%, 1=75%, 2=70%, 3=75%, 4=100%
ST-2: same as ST-1 above
PITCURVE: 0=36.5%, 1=51%, 2=65%, 3=74.5%, 4=84%
ST-1: 0=21,5%, 1=37,5%, 2=52,5%, 3=67,5%, 4=82.5%
ST-2: same as ST-1 above
HOLD: 0=0%, 1=25%, 2=50%, 3=75%, 4=100%

With these configurations, you can easyli fly it without hasle, just slowly throtle up about a few inches from ground, pay attention to forward/aft movement of heli ( FBL heli always tend to move back and forth a bit when hover near ground). Also slightly correct tail if there's some dragging on left( with tail in hovering). Never take off heli while using left/right input, this will cause 3aXis to react and will make heli tip over, resulting broken blades and stripping servos!just give enough throtle to make heli lift off a few inches then use cyclic sticks to correct.
However, if you're still afraid to handle heli, use the HOV.P/ FLAP switch on TX( top left) to increase pitch near max (all up), this will make heli less agressive and easier to fly.You can leave it as is or return it to midle once dominate heli.
note: always activate timer on TX between 4~5' flight for better Lipo's life and crash prevention. Stock lipo is 5' sport fly.

2011/Jan/27
ALWAYSCRASH

### Images

 Similar Threads Category Thread Thread Starter Forum Replies Last Post Discussion Got my Swamp Dawg.... But need help programing my DX6i hotrodder Racing Boats - Electric 4 Dec 11, 2011 10:56 AM Discussion Got my new plane! Getting ready for maiden, question about cg, need help please. cfiiman Electric Plane Talk 5 Jun 07, 2011 12:10 PM Found Used Tx for my Walkera CB-180Z, or combo package jjetmec Aircraft - Electric - Helis (FS/W) 4 May 19, 2011 05:34 PM Question walkera 4f200 stock setup on a tx 2801 pro xx_vengeful_xx Micro Helis 1 Mar 26, 2011 09:43 PM Help! Walkera 4F200 - change of Main Gear HM-4F200-7-09 JumboA5 Micro Helis 1 Dec 27, 2010 01:46 PM