Bantam BC-8 DP problem - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Jul 06, 2011, 03:12 AM
Addicted
Parakos's Avatar
Discussion

Bantam BC-8 DP problem


I have had this charger now for a couple of months and have started to feel that almost all my batteries have lost power since I started to use this charger. It's like it's not charging them to full capacity.

First incident was with my foamy SU-34 which I run on 4S 4000mah 40C batts. After one min the plane lost power and soon after the ESC cuts off the motor and I thought the ESC/motor burned... This was on a suposed fully charged batt.

After that I have experienced considerably less flight times since I started to use this charger.

I tested to charge the same batteries on my other charger (Turnigy 200W charger) and after that the batteries came back to life!

Any clues? Perhaps the batteries are bad and the BC-8 detects that and cuts off earlier?
Sign up now
to remove ads between posts
Jul 06, 2011, 05:03 AM
Registered User
Quote:
Originally Posted by Parakos
I have had this charger now for a couple of months and have started to feel that almost all my batteries have lost power since I started to use this charger. It's like it's not charging them to full capacity.

First incident was with my foamy SU-34 which I run on 4S 4000mah 40C batts. After one min the plane lost power and soon after the ESC cuts off the motor and I thought the ESC/motor burned... This was on a suposed fully charged batt.

After that I have experienced considerably less flight times since I started to use this charger.

I tested to charge the same batteries on my other charger (Turnigy 200W charger) and after that the batteries came back to life!

Any clues? Perhaps the batteries are bad and the BC-8 detects that and cuts off earlier?
Sounds like you are not using the right charge program or have a setting that is not correct, possibly terminating the charge early. Since the BC8DP has many advanced settings that in most cases should be left to the default values, you may want to go to the Setup and do a factory reset. This will reset the charger to factory defaults as well as erase any settings you have set.
Jul 06, 2011, 05:33 AM
Addicted
Parakos's Avatar
Quote:
Originally Posted by RC Accessory
Sounds like you are not using the right charge program or have a setting that is not correct, possibly terminating the charge early. Since the BC8DP has many advanced settings that in most cases should be left to the default values, you may want to go to the Setup and do a factory reset. This will reset the charger to factory defaults as well as erase any settings you have set.
Will try the factory reset and see if that helps.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Article Bantam e-Station BC-8 Balancing NiCd/NiMH and LiPo Charger Review Tram Batteries and Chargers 98 May 01, 2017 10:16 PM
Sold Bantam BC-8 DC Lipo Charger - Mint - $ 79 flywoody3 Aircraft - Electric - Batteries & Chargers (FS/W) 3 May 14, 2011 12:27 PM
Discussion Bantam BC 8 software problem jhai Batteries and Chargers 15 Sep 10, 2009 04:34 AM
Discussion Mini review of bantam BC-8 charger rcfury Batteries and Chargers 2 Mar 30, 2007 12:37 PM
Question E-Sky Bantam BC-8 Charger RC-PILOT Batteries and Chargers 2 Jan 31, 2007 05:23 PM