GWS EPO Zero, still need mods? - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Jun 28, 2011, 08:24 AM
Registered User

GWS EPO Zero, still need mods?

I was looking at the GWS Zero at Heads Up and thought it might be a cheap project to do something for a stand-off scale sport plane. I searched on some threads on it and found a bunch that said GWS has a zero where you either had to decrease the wing angle of attack or it was unflyable.

Is that the case with the current EPO GWS Zero?

Or was that only for older versions?

Sign up now
to remove ads between posts
Jun 28, 2011, 12:09 PM
Confused? Who, me?
Roger Lombard's Avatar
I very much doubt the wing incidence was changed when they changed from EPS to EPO. Having said that the incidence change is dead easy. Glue the wing retaining plate on the fuselage as low in its recess as possible. Glue the wing retaining plate on the wing as high in its recess as possible. Sand 1/16 -1/8" from the fuselage in a taper towards the rear of the wing seat. You're trying to get the leading edge down by 1/16-1/8 and the trailing edge up by a similar amount.

The Zero is the oldest GWS warbird and is pretty crude by modern standards but it is a great sports flier. Orginally designed for about a 30W powerplant it loves something of around 120 -150 (which is why the wing incidence needs changing).

Put more power in if you must but for me the 120-150 watt set-up gives you all you need for a fun flyer with unlimited vertical.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Alert New GWS EPO Zero!!! and other new Zeros.. bartricky Parkflyers 28 Sep 03, 2011 07:24 AM
Sold Hobby-Lobby EPO A6M5c Zero w/ Retracts $100 shipped! ohsnap Aircraft - Electric - Airplanes (FS/W) 11 Jun 16, 2011 11:51 PM
For Sale GWS EPO FOAM ARFs billbo1970 Aircraft - Electric - Airplanes (FS/W) 25 Jun 01, 2011 08:39 PM
Sold Hobby-Lobby EPO A6M5c Zero w/ Retracts ohsnap Aircraft - Electric - Airplanes (FS/W) 1 May 09, 2011 04:32 PM
Need some GWS Zero brushless advice (still kinda a noob) Electricman Parkflyers 3 Jul 14, 2004 03:19 PM