Instruction Manual Error in J-Power T-45 50mm CG postion
I have just recieved an e-mail from J-Power regarding the CG shown in their T-45 50mm Instruction Manual. Further to my inquiries, they have now confirmed that the CG shown in their Instructions is indeed totally in-correct, and they have released a new diagram showing the correct intended position for the CG for the T-45 50mm. This is the e-mail :-
Thank you very much for your assistant on our quality control.
Yes. I got reply from our R&D department, the CG for T-45 is wrong in our manual, we revised the version already, enclosed I also put the right version as per ref. Refer attached new drawing for T-45 CG.
We are sorry to bring you this problems. and sincerely appreciate your help on the quality control on our products.
Hopefully this info will be of use to new T-45 owners. I got concerned that the picture shown in the manual may have been incorrect, when I realised that every other J-Power EDF plane manual used the front of the wing (or where it meets the fusalage) as the reference point to measure where the actual CG should be.
For those that don't know the T-45, the instruction manual incorrectly shows the CG mark as being on the left hand vertical marker line in the picture, i.e the front of the wing where it meets the fusalage, instead of the right hand marker line . The correct "stock" CG position is now shown below.
Last edited by JonDv; Jun 20, 2011 at 07:14 AM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Alert||Banana Hobby/J-Power 50mm A-10 EDF Failures||Ducati0749||Foamy EDFs||5||Oct 27, 2011 05:25 PM|
|Contest||J power 50mm speed compitition!!!!||corsair nut||Foamy EDFs||90||May 18, 2011 11:07 AM|
|Rant||J Perkins Distrib - Why no 50mm J Power/Skyangel in UK?????||Jacques.Eloff||Foamy EDFs||10||May 16, 2011 04:29 AM|
|Build Log||HSW J-Power 50mm T-45||SkylineFlyer||Foamy EDFs||31||Dec 21, 2010 10:49 PM|