Skyangel/HK Mig-15/29, F-86, T-45, F-15/16/18 and A-10 35mm EDF Jets now available! - Page 41 - RC Groups
Thread Tools
Jul 16, 2011, 11:58 PM
Life begins at transition
It doesn't sound right, full stop!
Sign up now
to remove ads between posts
Jul 17, 2011, 02:29 AM
Registered User
mihah's Avatar
Yesterday speed testing (Rc Speedo) of tje mig-15 on 3s with tt - 124 kph from a slight dive :-)
Jul 17, 2011, 08:42 AM
From a Different Planet!
edge_pilot's Avatar
thats screaming for something of this size!
Jul 17, 2011, 09:26 AM
For Sale-everything over 250 g

Mig-15 spins


I did some spin testing last night. Since moving the CG forward it won't flat spin.

It will death spiral as long as power is on, but it's not easy to get into one. Low speed, full throttle and it snaps over into one. Basically it's a hand launch gone bad. Reduce power and it comes out right away. Keep power on and it'll spiral into the ground no matter what you do on the sticks. Thrust angle correction should pervent it.
Jul 17, 2011, 10:04 AM
Registered User
mihah's Avatar
Quote:
Originally Posted by edge_pilot
thats screaming for something of this size!

Enough to get everyone's attention at the field. Today I balanced the fan since after about 20 flights yesterday it got quite noisy. Now it really makes "woosh", I think it is little bit faster now, maybe can touch 130 kph (80 mph).
Jul 17, 2011, 04:11 PM
Richard Cox
My stock plane from BH with a Rhino 2S360 was tail heavy, so I added 1/4 oz lead in the nose, cutting out some foam so it fits almost flush. I ran into a steel weight in the nose!

I stalled it up high trying to do a loop, and it recovered OK.

Today I treed it about 50 feet up. The wind may eventually blow it down, but I ordered a replacement already.
Jul 17, 2011, 04:25 PM
Electronics and RC
MegaTesla's Avatar
Quote:
Originally Posted by Richard Cox
My stock plane from BH with a Rhino 2S360 was tail heavy, so I added 1/4 oz lead in the nose, cutting out some foam so it fits almost flush. I ran into a steel weight in the nose!

I stalled it up high trying to do a loop, and it recovered OK.

Today I treed it about 50 feet up. The wind may eventually blow it down, but I ordered a replacement already.
Running into anything made of steel can be hazardous to your health!
Jul 17, 2011, 07:11 PM
Registered User
dude_109's Avatar
Quote:
Originally Posted by MegaTesla
I got a duration flight in on the Sabre today. I wanted to see what all this 2s complaining was about, so I put a 2s 800mAh nano in there. Same size as the 460mAh 3s. I had to fly almost WOT most of the time to keep it in the air. It was a very boring flight that lasted nearly 10 minutes!
I like the sound of that. I've got some 2S between 610 & 800 that can be put to use then. Bring on some more new mainframe already!!!!
Jul 17, 2011, 08:58 PM
Not enough hours in the day
Slaanesh's Avatar
My previous unflyable state was just a rearward CoG position.
I put a single dollar coin in my F-86 2S setup and it transformed my plane from unflyable to satisfactory.
I hate dead weight so when I got home I clean up it's nose - which had a few crinkles from "nose landings" and glassed the 5cm of it's nose. This added some much need weight but at least in a functional manner.

I've lighted almost everything in the tail - except for the metal pushrods. I've got some 0.6mm CF rods coming though.

How much lighter is EPS compared to EPO? 20% lighter airframe would certainly be worth it.
Jul 17, 2011, 11:09 PM
For Sale-everything over 250 g
Mig-15 grass takeoffs. Stock motor and fan, 3s 320mAh Hyperion, CC T-Bird 9.

35mm EDF grass takeoff (2 min 10 sec)
Last edited by mcross; Jul 18, 2011 at 06:37 AM.
Jul 18, 2011, 12:44 AM
Registered User
Quote:
Originally Posted by mcross
Very nice video

Is this the stock PnP version ?

Or you are on 3S or some special EDF ?

Thanks

e_lm_70
Last edited by e_lm_70; Jul 18, 2011 at 04:24 AM.
Jul 18, 2011, 02:57 AM
Registered User
mihah's Avatar
Quote:
Originally Posted by mihah
Yesterday speed testing (Rc Speedo) of tje mig-15 on 3s with tt - 124 kph from a slight dive :-)
Some photos from Saturday.
Jul 18, 2011, 07:49 AM
For Sale-everything over 250 g
Quote:
Originally Posted by Richard Cox
I ran into a steel weight in the nose!
Nice find, Richard. I'll have to replace that with more liPo.
Jul 18, 2011, 09:29 AM
Team30 Micro EDF
NitroCharged's Avatar
Where-a-bouts is this weight Richard?

Nice grass take-off Mike!
Jul 18, 2011, 11:25 AM
its TALON TIME!
corsair nut's Avatar
mike, that does awsome for the stock motor on 3s! tons of power!

ok...now i have to get one..


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Mini Mig-15 EDF from Hobby King Dreamcatcher Foamy EDFs 6 Jan 16, 2012 10:58 AM
New Product JPower/Banana Hobby 40mm Foam Mig-15 and F-86 ducted fan Mikey 68 Micro EDF Jets and Power Systems 557 Aug 18, 2011 06:01 PM
Build Log Hobby King Micro A-6 & F-86 Jets tallflyer Foamy EDFs 4 Jun 04, 2011 03:05 PM
New Product J-Power 30mm EDF Jets (F-86 & Mig-15) xplaneguy Foamy EDFs 1 Jan 16, 2011 06:59 AM
Park/indoor EDF F-86 and MiG-15 production news! Thomas B Parkflyers 8 Feb 06, 2002 07:30 PM