|
|
|
|
this one is light years ahead of the others, as Doc said.
http://code.google.com/p/mwii-preflight/downloads/list |
|
|
|
|
|
Install this first
http://code.google.com/p/mwii-prefli...e.zip&can=2&q= then move the Pre-flight 12 file into same directory, oops. For you new windows guys , move into Folder! |
|
Last edited by DoctorAudio; Jan 17, 2013 at 11:14 AM.
|
|
|||
|
Here's a video comparing the flight characteristics of the Quadrino board with those of the KK2.0 board using the latest firmware. Both are used to control the same home-brew mini-quad, flown over the same course.
|
||
|
|||
|
|
|
So simple, but more than a thousand words.
|
|
|
|
|
|
|
|
|
|
|
|
FlyingEinstein will be hosting a webex class each Sunday @ 3PM EST for an introduction to wiring the Quadrino and initial installation and configuration of the MultiWii Configuration software. This is a group discussion and a Question and Answer period will follow and asking questions during the webex is also encouraged. If you are having difficulties with setting up the Quadrino this is your chance to get your questions answered and your quad flying.
This class is offered through Cisco WebEx and supports up to 25 attendees at a time. To join the meeting goto flyingeinstein.webex.com between 2:45 PM and 3:00PM EST. The meeting will open at 2:45PM but will not begin until 3PM. Password is always "quad" Go to flyingeinstein.webex.com |
|
|
|
|||
|
|
||
|
|||
|
|
|
One more Quadrino ready for the air and pickup.
DJI Hex and my Y6 |
|
|
|
|
|
I think I got it set up right now.
Video is uploading now.
|
|
|
|
|||
|
I think I got it set up right now.
Video is uploading now.
only change the POS POR NAVR settings.
3 flights in a row and best best was with in 5 feet diameter! Worst was like 10 feet! |
||
|
Last edited by DoctorAudio; Jan 27, 2013 at 12:24 AM.
|
||
|
|
|
FlyingEinstein will be hosting a webex class each Sunday @ 3PM EST for an introduction to wiring the Quadrino and initial installation and configuration of the MultiWii Configuration software. This is a group discussion and a Question and Answer period will follow and asking questions during the webex is also encouraged. If you are having difficulties with setting up the Quadrino this is your chance to get your questions answered and your quad flying.
This class is offered through Cisco WebEx and supports up to 25 attendees at a time. To join the meeting goto flyingeinstein.webex.com between 2:45 PM and 3:00PM EST. The meeting will open at 2:45PM but will not begin until 3PM. Password is always "quad" Go to flyingeinstein.webex.com |
|
|
|
|
|
Nice DA. . . you really seem to be getting that GPS pos hold dialed in
I got a couple of questions as I am trying to setup my quadrino on a y6 w/ 2 axis gimbal output. . if possible. 1. Can I configure the ppm output channels in the arduino sketch? I need thr, ail, elev, rudd but I can't find that ppm setup in the sketch 2. Would it be best to solder pinheaders to the srv1 and srv2 to for the gimbal outputs? TIA for your advice |
|
Last edited by Danub; Jan 27, 2013 at 09:03 PM.
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Review | Hangar 9's Piper J-3 Cub 40 Plug-N-Play PNP Plug N Play Evo 46NT Powered ARF Review | tailskid2 | Scale Fuel Planes | 20 | Mar 09, 2018 08:44 PM |
Help! | need new flight controller recommendations | n3m1s1s | Multirotor Drone Talk | 115 | Jan 09, 2012 10:38 AM |
Subsonic's Motrolfly Plug and Play Power System: Motor, Controller & Battery Review | Michael Heer | Electric Power Systems | 27 | Dec 16, 2010 01:36 PM | |
Data | Plug 'n Play separates: An Esky CP2 with an E-flight 2 in 1... | elan | Micro Helis | 3 | Mar 19, 2010 08:51 AM |
Discussion | Air Hogs Plug n'Play Flight Deck Simulator | trust416 | Micro Ready-to-Fly | 14 | Aug 05, 2007 10:44 AM |