VTOL code for RCVertt - RC Groups
Thread Tools
This thread is privately moderated by cass3825, who may elect to delete unwanted replies.
May 12, 2011, 12:29 PM
Registered User

VTOL code for RCVertt

Servo pin assignments:

A0, A1: elevons/tailerons
A2: fan door
A3: retract
D8: yaw
D12: front motor tilt

The fan door, retract and front motor tilt servo signals are currently driven from the rx signal connected to pin 7. the front motor tilt servo has been stretched from 800us to 2133us to see if my crackpot timer manipulation will work.

Fingers crossed,

EDIT: Found a flaw in the timer manipulation, should be fixed now.
EDIT2 (actually around the 4th edit, but who's counting? LOL):Finally found the timer rollover issue.
Revising the revised revision: Reduced resolution to stretch servo from 500-2500uS.
Last edited by cass3825; May 13, 2011 at 04:13 PM.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
New Product 6DOF 10DOF 11DOF IMU All In ONE+ MCU and ALL in ONE II with GPS and sensors CSG_EU Multirotor Drone Talk 116 Jun 24, 2015 11:46 AM
Alert Hobbyking BuddyPrice Code $12.20 for 560w NTM motor lrplin Hot Online Deals 11 Feb 15, 2014 04:26 PM
Discussion Angle of blades for dual rotor VTOL rcjetflyer2 VTOLs 6 May 16, 2011 07:32 PM
Question Angle of blades for dual rotor VTOL rcjetflyer2 Foamies (Scratchbuilt) 1 May 08, 2011 06:02 PM