Retrofitting my ArrowPro DLG - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by rkhoo, who may elect to delete unwanted replies.
May 12, 2011, 01:08 AM
Fly by grace
rkhoo's Avatar
Build Log

Retrofitting my ArrowPro DLG

I have been flying the ArrowPro for a few years. It is time to bring it up to date with foam tails from obi.

I have a few questions on how to install it:

1. The mount
a. Is the flaps suppose to fit perfectly on the boom? As it is now, only a few point are in contact with the boom when mounted.
b. Glue with CA or Epoxy?
c. Do you use any pads between mount and horizontal tail?

2. What is the purpose of the aluminium tubes? What are those red plastic taps for?

3. Rudder
a. How do you use the strings?

4. Elevator
a. Do you use any guides for the steel spring?
b. Does the string go thru a teflon tube? inside or outside the boom?

Question,questions and more questions

It would be very nice if there is a installation diagrams.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Please review my DX7 setup for DLG jfflyer Hand Launch 5 May 11, 2013 02:20 PM
Discussion Hope the DLG Gods forgive Avenger is electrified! hog2soar Hand Launch 5 Mar 20, 2011 09:44 AM
Question Dlg Flaps on my Evo??? soarsimon Hand Launch 20 Mar 09, 2011 05:23 PM
Discussion Retrofitting my first plane frogman1206 Aerial Photography 13 Oct 25, 2009 12:26 AM