No problem with dc (brushed) motors but ac/3 phase (brushless) might not start up if not exactly the same.
So if you want to try you must use 2 exactly the same motors and props.
The reason is that the coil that will be powered by the esc is "decided" after measuring the location of the magnets.
It can only do that for one motor so if the other "gets behind" when turning (and when starting) the wrong coil in that motor will be powered and then the motor will shake back and forth but not rotate.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Can you run 2 brushless motors from 1 ESC???||SGTalon||Power Systems||1||Jun 30, 2006 09:20 AM|
|Can I use a 2 cell brushless ESC with a single cell micro joule system?||Matthew Cotten||Scratchbuilt Indoor and Micro Models||2||Jul 05, 2005 09:19 AM|
|can you run 2 motors on one speed controler||jswjimmy||Power Systems||8||Nov 22, 2004 04:52 PM|
|can you run 2 brushless motors off of one esc?||jeff262||Power Systems||4||May 30, 2004 11:39 PM|
|Can you run 2 brushless motors off of one ESC||nikolaus_c||Power Systems||1||Jul 05, 2003 11:44 AM|