Making Patterns from drawings for scratch built planes
I don't know if anyone has ever tried this, but I was monkeying around with Photoshop and loaded a pdf manual for the Corsair kit from Top Flite.
I created canvases exactly the same as the Balsa and plywood dimensions in the book, and then scaled the individual drawings to the material size.
Looks ok, but will it fly? Any ideas? Anyone ever try this?
I'll upload a couple of samples for you to see.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Not enough power for my scratch built F-15||noaman||Pusher Prop Jet Models||9||Mar 30, 2011 04:06 PM|
|Discussion||recommendations for a scratch built RET trainer for backyard f||Viking goes Thud||Foamies (Scratchbuilt)||7||Mar 29, 2011 11:08 PM|
|Discussion||recommendations for a scratch built RET trainer for backyard flying||Viking goes Thud||Scratchbuilt Indoor and Micro Models||10||Mar 29, 2011 09:21 PM|
|Help!||Where to find a canopy for scratch built Lancaster?||flying jeep||Electric Warbirds||14||Mar 25, 2011 06:36 PM|
|Discussion||Thread for scratch built planes created from Vapor guts||SkyeHighRC||Micro Ready-to-Fly||7||Sep 03, 2009 10:55 AM|