revised Arm switch gui - RC Groups
Thread Tools
This thread is privately moderated by cass3825, who may elect to delete unwanted replies.
Apr 20, 2011, 05:28 PM
Registered User

revised Arm switch gui

fixed EEPROM read

revised sketch to not arm the motors if the copter is plugged while the tx switch is in the armed position. you must switch to disarm position then back to arm position in order to arm the motors.
Last edited by cass3825; Apr 21, 2011 at 02:00 PM. Reason: added mac gui
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion MultiWii GUI freeze troubleshooting power Multirotor Drone Talk 16 May 08, 2011 04:14 PM
Sold S*a*l*e* #2 (REVISED) flyinjrc74 Non R/C Items (FS/W) 5 Apr 22, 2011 12:57 PM
Discussion 3 position switch instead of 2 position switch ??? vlatko DIY Electronics 3 Mar 20, 2011 08:48 AM
Sold 150mg out-put arm Actuator (Leichty) and nano-switch. arclite5 Aircraft - General - Miscellaneous (FS/W) 5 Aug 29, 2006 01:52 PM