making aileron pushrods - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by JLT_GTI, who may elect to delete unwanted replies.
Apr 03, 2011, 08:21 PM
Registered User
JLT_GTI's Avatar

making aileron pushrods

Curiously those were far easier than making the pushrods for the CloudsFly wich are made from far thinier wire with snap connectors..

Lookin for ideas i found a nice procedure of making snake-bend pushrods bends

As the Ninja has 4 threaded 1,5mm diameter wires..and since im using dual wing servos rather than a single servo i had 2 left.. so making the snake bend and cutting and they were ready... and the quick links from the kit make them easy to adjust afterwards if needed (unlike the snap conector ones wich require unscrewing a not so good quality screw)..

With this.. only "glueing" the servos in place and installing electronics is left apart from final covering.. wich will take more time to decide than make itself probably
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion CX2 - Aileron and Elevator Pushrods?? sgomes Coaxial Helicopters 9 Jan 01, 2007 11:46 AM
Discussion Aileron pushrods Fly2High Hand Launch 5 May 10, 2006 06:20 AM
Need help making pushrods dwoel Thermal 3 Oct 31, 2005 06:48 PM
Carbon Tail Pushrods - Sizing and Making?? CustomPC Electric Heli Talk 5 Sep 05, 2005 09:08 PM
Question Help-Is this to much of an angle for aileron pushrods? Sammy B 3D Flying 8 May 01, 2005 09:53 AM