Extra Build day 2 - RC Groups
Thread Tools
This thread is privately moderated by jonnyspeed, who may elect to delete unwanted replies.
Mar 19, 2011, 07:36 PM
Registered User
jonnyspeed's Avatar

Extra Build day 2

Had to cut day two short due to a lack of 30 min. epoxy. Grrr.... I thought for sure I had some, but nope. LHS is closed now so I'll have to pick some up after Church tomorrow. I've got all the servos and the Rx installed. I'm running a Spektrum AR6200. I think I will add the Telemeltry modual too before I put her up. I really like the way the gear mounts to the fuse. very slick. The pants are high quality, and the built in blindnuts made the install a snap. I just hope there is enough plywood in there. Seems like the last few ARFs I've built wind up pulling the gear out. We shall see.

Sign up now
to remove ads between posts
Mar 20, 2011, 11:03 AM
Yeeah buddy!
PinkYakRC's Avatar
If you think that you will rip out the landing gear, mabey you should make it stronger now, insted of having to repair it later.
Mar 21, 2011, 11:12 AM
Registered User
jonnyspeed's Avatar
Good point. I'm gonna see if there is anything I can do to add strength without too much additional weight. Our grass field has some bumps that aren't kind at times.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Micro glider build-off!! 2 day!! watersharer Scratchbuilt Indoor and Micro Models 31 Apr 03, 2005 10:56 PM