Brushless rpm sensor works in live mode but saved data doesn't show reading
Brushless rpm sensor works in live mode but saved data doesn't show reading for the motor. I used to work a while back, but quit after a firmware update. I didn't bother with it anymore after that untill last nite. I needed info regarding timing increase and motor rpm. I used my older V3 logger and could see the motor rpm show data in live mode. When I stop the live mode, I'm asked to save the data. Once saved I can still see the rpm reading in the log. The problem starts when I close the session and reopen it. Everything is there except the motor rpm data.
So is this a software issue or am I missing a setting somewhere?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||HPP-22 software connects, but sensor display doesn't work||creativez||Hitec/Multiplex USA||2||Jan 31, 2011 10:02 AM|
|Discussion||Brushless Motor RPM Sensor||007clint||Eagle Tree Systems||1||Oct 20, 2010 12:04 AM|
|Discussion||Brushless RPM sensor with eLogger V3 doesn't work||Imbuter2000||Eagle Tree Systems||2||Apr 11, 2010 11:58 AM|
|Discussion||Different reading on RPM brushless sensor with and without prop||stemasoft||Eagle Tree Systems||6||Jun 24, 2009 07:34 PM|
|What!? Laser 4 suddenly doesn't work at all after wal-wart charge but works as mstr||jay flay tway||Radios||7||May 16, 2005 03:49 AM|