mCP X settings for the Futaba 10CHP - RC Groups
Thread Tools
This thread is privately moderated by turboparker, who may elect to delete unwanted replies.
Mar 12, 2011, 04:33 PM
I'd rather be flying!
turboparker's Avatar

mCP X settings for the Futaba 10CHP

For those who are flying or plan to fly the mCP X with a Futaba module-based tx + Spektrum module, here are the settings I'm using on my 10CHP. I also attached a Word doc. Should be a good starting point, at least. As always - use at your own risk.

I encourage those who try them to post their results and any alternate settings in this thread.

EDIT 4/17/11: When I set up the curves, was not aware that hover-pitch & hover-throttle were activated in 'normal' mode. Now that I have corrected the problem, I have updated the attachment & info below to reflect my new settings. Sorry for any confusion this may have caused.


D/R (switch D):
Low: 70%
High: 100%
Expo: -30%
Note: D/R & Expo on Ch 1 & 2 only

End Point

1 Aile 90/90
2 Elev 90/90
3 Thro 100/100
4 Rudd 100/100
5 Gyro 100/100
6 Pitch 70/70

Reverse: 1 Aile, 2 Elev, 3 Thro, 4 Rudd, 6 Pitc

Type: Helicopter
Swash: H-1
Modul: PPM

Gyro Sense

Idle-up: Switch E
1) Center
2) Down
3) Inhibit

Throttle Hold: Switch G Down
Last edited by turboparker; Apr 17, 2011 at 06:17 PM. Reason: New settings
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Flight time for MCP X ? omer921 Micro Helis 13 Feb 19, 2011 02:13 PM
Wanted WANTED: Futaba 10chp working or not tahoelight Aircraft - General - Radio Equipment (FS/W) 1 Nov 03, 2010 12:45 AM
Sold REDUCED!!FUTABA 10CHP 2.4Ghz Alexis_Ruiz Aircraft - General - Radio Equipment (FS/W) 13 Sep 24, 2010 01:04 AM
Sold Nearly new Futaba 10CHP 2.4 Fasst AND Spektrum Module for Futaba cryhavoc38 Aircraft - General - Radio Equipment (FS/W) 1 Jul 24, 2009 04:39 AM