I need some feedback on a new idea of mine. (wiring diagram attached)
so I just threw this wiring diagram together as somewhere to start... I need feedback to see if it will even work. and what needs to be fixed to get into the building process.
Im going to use basic x( Left and right) y(up and down) and z axis orientation for the discription.
the basic idea is a tri-copter using propped brushless outrunners. dual props in the front of the aircraft (left of diagram), and the third centered in the rear. I want all the motors to tilt independently along the x axis: all foreward for FF, same for reverse flight, two front motors in opposite direction for rudder/yaw rotation (along the z axis). I am hoping that I can use variable thrust on the two front motors in order to induce roll along the x.
so a couple of questions of mine are:
can I put the esc's in the circuit that I have attached?
is my idea even feasible?
Please any feedback is welcome? I am pretty new to this and being quite ambitious.
This would be mechanical thrust vectoring to control flight as an alternative to varying the thrust on the three motors. If it has been tried it would probably be on the multi rotor helocopters subforum, and it might be a good place to get an opinion on it too:
Multi Rotor Helis - https://www.rcgroups.com/multi-rotor-helis-659/
It would seem to be a more complicated way to do it to me.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Need help on wiring diagram||jshander||Dock Talk||0||Feb 03, 2011 11:32 PM|
|Idea||esc fan idea i need some opinions on!||TRAXXAS DEMO||Electric Power Cars||12||Oct 17, 2010 04:52 PM|
|Discussion||Need a Wiring Diagram||TigerI||Batteries and Chargers||1||Sep 02, 2010 07:19 PM|
|Help!||Need confirmation on battery wiring (diagram inside)||steve1814||Batteries and Chargers||2||Oct 04, 2008 09:02 AM|
|need some feedback on Supertigre G90||MrPropJet||Engines||2||Nov 06, 2004 08:59 AM|