Airborn 1600 build Fuselage sides finishing
I have made all the side pieces of the fuselages and have them ready to be joined
Also the wedge piece at the very tail of the fuselage is glued to one side before
joining the sides, it is a piece of 3/8" x 1.5" Trailing edge. The notch is to clear the rudder mounting
screw going up from the bottom the the stab and the other notch is the hardwood crossmount for
the horizontal stab itself. Also is shown how I sand the sides flat.
A Sanding T with the fuselage side pressed against a sanding board
with sandpaper attached to it.
ImagesView all Images in thread
Last edited by Jay Burkart; Feb 23, 2011 at 09:26 PM.