Thread Tools
Feb 05, 2011, 01:39 PM
Registered User
daneflyer's Avatar
Discussion

binding spectrum receiver problem


I am trying to bind my spectrum ar500 receiver installed in a new aircraft to my dx6i which i have done many times before. When I plug the battery in to the ESC the led on the receiver only blinks once and the servos center but the led doesn't continue to blink and the receiver will not bind. Thought maybe it was the receiver since it came out of a wrecked plane, but had the same thing happen with another receiver. Any ideas?

Thanks for the help,

Dan
Sign up now
to remove ads between posts
Feb 05, 2011, 01:42 PM
Karma's Evil Twin Brother
Is your transmitter off when you plug in the battery?
Do you have the bind plug in the right port on the rx?

Maybe dumb questions on my part, but it's a good place to start
Feb 05, 2011, 02:05 PM
Registered User
daneflyer's Avatar
Quote:
Originally Posted by Bad Karma
Is your transmitter off when you plug in the battery?
Do you have the bind plug in the right port on the rx?

Maybe dumb questions on my part, but it's a good place to start
Fixed the problem. After posting my problem I found a post that suggested trying a different bind plug,....that fixed the problem. Are bind plugs different for different receiver? I have a couple different receivers, but put all the bind plugs in one plastic bag. Thought maybe bind plugs are specific to the receiver model. All of them are Spectrum.
Feb 06, 2011, 05:35 AM
Will fly for food
Nope, all they are is a connector that has the two outer pins connected.

But I have heard of bad bind plugs, probably a missed crimp or a broen wire inside the insulation.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! Spectrum DX7 Binding problem wilchar Fuel Plane Talk 0 Jul 05, 2010 10:23 AM
Discussion Spectrum DX6i memory loss and binding problem Derek_S Radios 4 Jun 20, 2009 10:35 AM
Help! Binding 2 JR 9 spectrum receiver at the same time? gouang Radios 1 Jan 24, 2009 08:55 AM
Discussion 2.4 G system from walkera - problem binding new receiver klausbub Radios 0 Feb 15, 2008 02:23 AM