Thread Tools
This thread is privately moderated by cass3825, who may elect to delete unwanted replies.
Old Jan 15, 2011, 10:33 PM
cass3825 is offline
Find More Posts by cass3825
Registered User
Discussion

Processing GUI


testGUI
Sign up now
to remove ads between posts
Old Jan 17, 2011, 10:59 PM
cass3825 is offline
Find More Posts by cass3825
Registered User

belt driven cp quad idea


just a sketch... The motor pinion in the center will mesh with two opposing gears like this (top and bottom gears in the pic). The other gears (left and right) will mesh with the top and bottom gears, rotating in the opposite direction.
Last edited by cass3825; Jan 17, 2011 at 11:16 PM. Reason: revised explanation...
Old Feb 01, 2011, 06:07 PM
cass3825 is offline
Find More Posts by cass3825
Registered User

'duino sketch...


for Jussi.
Old Feb 27, 2011, 03:00 AM
krial is offline
Find More Posts by krial
Registered User
Quote:
Originally Posted by cass3825 View Post
just a sketch... The motor pinion in the center will mesh with two opposing gears like this (top and bottom gears in the pic). The other gears (left and right) will mesh with the top and bottom gears, rotating in the opposite direction.
Its nice to see others also is pondering on the idea of a variable pitch multirotor. Your idea is very good, but I think it need a one way bearing somewhere, because if you use heli blades, their momentum will rip apart the gears when you cut throttle.

What if you put a 450 main gear with the clutch bearing in the middle and let this mesh with the four gears with the belt pulleys?

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Fromeco "ion3 Cube" 3-port with GUI display (Li-ion) aero104 Aircraft - Electric - Batteries & Chargers (FS/W) 4 Jan 05, 2011 09:35 PM