|
|
Thread OP
|
Help!
Arduino pro mini - 3.3v or 5v
Hi guys I have a pretty newbie question but I'll ask anyway anyway: for the MultiWiiCopter brain, should I get the 3.3v or 5v version of the Arduino Pro Mini? I've been hearing the WM+ likes the 3.3v but I wasn't sure if there was another component that relies on the 5 volts.
Thanks, Gray |
|
|
|
|
||
|
Quote:
Jim |
|
|
||
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Sold | 3 Turnigy 3S 11.3V 2650mAh 30C NEW | btpalc | Aircraft - Electric - Batteries & Chargers (FS/W) | 5 | Dec 05, 2010 12:19 AM |
Discussion | Servo 3.3v signal with 5v/6v supply? | Razor_Racer | Radios | 1 | Oct 15, 2009 05:38 AM |
Discussion | 3.3V RX output to 5V esc input | twang | DIY Electronics | 16 | Dec 27, 2008 08:42 PM |
Discussion | 5V bus and 3.3V bus | FredFl | DIY Electronics | 1 | Dec 10, 2008 05:30 AM |
Discussion | reading a 5v sensor with a 3.3v adc | 4mla1fn | DIY Electronics | 2 | Jul 27, 2007 11:33 PM |