I have a different version of the n6 transmitter, FCC ID is V6KCY246.
No binding button! There is a space on the pc board where a button could be soldered in, but none was. There are three connections, labeled G,+, and unmarked. There are also five connections on the other side of the pc board which may or may not be important. I believe this is to set a pin on the main chip to high or low, but I don't know which is the normal setting and which the bind. Any help much appreciated.
Here are a few photos:
Last edited by devinvagt; Jan 08, 2011 at 02:32 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Convert an Airfield N4 Transmitter and XY400 Receiver to 6 channel||Ghost Plane||DIY Electronics||22||Jan 25, 2014 05:39 PM|
|For Sale||Airfield N4 transmitter for sale||krouth||Aircraft - General - Radio Equipment (FS/W)||0||Oct 22, 2010 07:26 AM|
|Sold||Airfield 2.4 Ghz Transmitter and Receiver||ZackJones||Aircraft - General - Radio Equipment (FS/W)||2||Oct 17, 2010 07:37 PM|
|Sold||Airfield RC N4 2.4G 4CH Transmitter and Receiver||Mikey 68||Aircraft - General - Radio Equipment (FS/W)||1||Aug 09, 2010 07:03 PM|