New Products Flash Sale
Thread Tools
This thread is privately moderated by Joffa_Dan, who may elect to delete unwanted replies.
Old Jan 02, 2011, 10:36 AM
Joffa_Dan is offline
Find More Posts by Joffa_Dan
Crash land!
Joffa_Dan's Avatar
Gallery

FPV Chevy Summit


Had some time over the christmas holiday to finally put this all together.

The Summit is running a Neu 1520 1Y 1600KV brushless with a Kershaw design motor mount. Mamba monster esc. The tyres are rc4wd Rok Lok 4.0, and bead locks are axial oversized narrows.

Using the stock summit 2.4Ghz at the moment for RC which is fairly poor. I have a corona 36mhz to put in which I will do asap.

The Video is a 1.2Ghz 800mw sunsky with Sn777 camera mounted to a servo (for pan) in the drivers seat. The whole video system is powered by the balance plug, on one of the two lipos powering the car.











Run times are an hour or so if I'm in first gear.

Turned out nicer than I thought it would!
Sign up now
to remove ads between posts
Old Jan 02, 2011, 11:23 AM
verticalspark is offline
Find More Posts by verticalspark
Aut Viam Inveniam Aut Faciam
verticalspark's Avatar
That is awesome!
Old Jan 05, 2011, 02:43 AM
GreenAce92 is offline
Find More Posts by GreenAce92
Physics hate's my ideas
GreenAce92's Avatar
Wow this is like a review! Incredible

Question... you mentioned being in "first gear"
So since you have an FPV setup, and I hope you have audio, do you do the transmission by sound? Also is there a clutch? How would you change gears via tx? ie what button or toggle/dial/switch etc?
Old Feb 16, 2011, 01:40 AM
Joffa_Dan is offline
Find More Posts by Joffa_Dan
Crash land!
Joffa_Dan's Avatar
The summit has both high and low gears and lockable diffs, all of which are controlled from the stock radio.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion FPV Tonka Summit replayreb FPV Talk 10815 Today 04:21 AM
Discussion Summit Willys Jeep FPV Specterx FPV Talk 4 Jun 01, 2011 05:45 PM