Help!! How do I splice my interface cord?
The interface cord that goes into my "buddy cord" socket on the back of my transmitter has developed a broken, ( intermittant ) connection at the end of the plug. The break in the wire is too close to the plug for me to be able to splice it and use the original plug. I bought a buddy cord and was going to cut it and splice one end to my interface cord. But it has three wires instead of the co-axial like the interface cord. Which wires do I splice to the two wires on the interface cord?
This is the RF/G2 printer port interface that lets me use my JR radio. The buddy cord has a black, a red, and a brown wire. The interface cord has a white sheath on the center wire, and is surrounded by the outer wire under the outer insulation.
Any help would be very appreciated.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|HELP! how do I change the address on my profile?||fumblefingers||Site Chat||3||Sep 30, 2003 08:34 AM|
|Help! How do I splice my simulator cord?||1g1yy||Radios||1||Aug 03, 2003 01:58 PM|
|Help! How do I get more vertical for my GWS P51||Mmarshall||Power Systems||14||Mar 11, 2003 10:18 PM|
|HELP! How do I set the Correct CG on my ASW-22?||marmal43||Electric Sailplanes||0||Aug 08, 2001 03:33 AM|
|Help! How do I retime my 6327 Graupner Speed 480 race motor for a gearbox.||Joe Elston||Electric Plane Talk||6||Apr 20, 2001 12:56 PM|