How can use switch Turnigy 9X(FW. ER9x) in Simulator - RC Groups
Thread Tools
Nov 17, 2010, 01:06 AM
Registered User

How can use switch Turnigy 9X(FW. ER9x) in Simulator

I have a Turnigy 9X TX v2. and I was upgraded firmware, ER9x.
I have some problem in Realflight G4.5.
I can use a nomal 4ch plane in simulator.
I can use a Throttle Cut switch {It was same real RC(Durafly Cessna 182) setting.}
But, I can't use a Flap and Gear switches my Tx.
(This mean, I use Flap my Real RC set ch6, but just it can't use simulater)

I think, it's need a setting something...
I was changed some plane setting to (Pass Though).

How can I use a switches.
Please, help me a setting knowhow (Transmitter and Simulator.) step by step

Thank you.
Last edited by NiceOh; Nov 17, 2010 at 01:13 AM.
Sign up now
to remove ads between posts
Nov 19, 2010, 03:38 AM
Registered User
I don't own that sim, but it could be that the interface will only recognise the first 5 channels (four gymbals and a switch) and the transmitter is sending the flap and gear as 6th and 7th channel, which isn't read. ??

Can you see the channels in any calibration screens and do they move when you activate the switches
Nov 23, 2010, 05:13 AM
222 km/hr Parkjet flyer
solentlife's Avatar
Some sims will not see the 'extra' ch's when Module is unplugged from Tx. This is a problem not of the Tx but of the Sim. You have to trial and see which does and which doesn't.

With RCPlanemaster - I get aux's ch's with module in, take it out and I lose ch's 5 and up.

HeliSimRC doesn't care

FMS ... that crashes anyway !

Oh and before anyone shouts ... you MUST take out module to stop Transmitting signal - rubbish. The trainer / DSC socket specifically on most radios disconnects RF signal ... Don't believe ? Then try this :

Plug in radio to PC ... it should come on without need to switch on. Now switch on model taking care of course ... any joy ? Didn't think so. Now switch on Tx and still zero ... now unplug cable ... Oh NOW you have life. BUT be warned - plugging cable back in now will NOT stop RF ... only switching of Tx switch will ... and then cable keeps radio on to work PC.
May 21, 2011, 10:51 AM
Registered User
I have the same problem,
Only if I go in "Display" in the menu, I see no switch movement
Is that normal?
This happens even if i turn my Rx on normally


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Turnigy 9x can't figure out flapperon Gigaah Radios 16 Mar 03, 2014 11:19 PM
Discussion How can convert simcable E-sky to turnigy 9x(JR port) NiceOh DIY Electronics 4 Nov 17, 2010 12:31 AM
Help! How can I to convert simcable E-sky to turnigy 9x? NiceOh Radios 0 Nov 15, 2010 05:58 AM
Help! Can't get my Turnigy 9X to work with Phoenix agent1940 Simulators 1 Oct 22, 2010 01:42 AM
Discussion How to use TH9x (Turnigy 9x, etc) with DX6 in trainer mode? polar8 Radios 7 Oct 19, 2010 03:04 AM