Thread Tools
Old Nov 12, 2010, 06:45 PM
xiaoyu80305 is offline
Find More Posts by xiaoyu80305
Registered User

Easyfly3 and DX8

I bought Easyfly3 with USB interface-cable and, I have DX8 radio. When I start the program, the error message shows: The USB Interface-Cable is found but not the radio. The cable came with the package has 2.5mm mono male on one end and 3.5mm stereo on other end. Will this be a problem? should I change to both mono male?
Sign up now
to remove ads between posts
Old Nov 13, 2010, 02:28 PM
bilboa is offline
Find More Posts by bilboa
Registered User
Shot in the dark, but do you have the DX8 switched on? The Spektrum radios need to have the power switch OFF when using them with a sim. They turn on in trainer mode automatically when you plug the trainer cord in. A stereo jack should work fine.
Old Nov 14, 2010, 01:35 PM
xiaoyu80305 is offline
Find More Posts by xiaoyu80305
Registered User
I resolved my problem by:

1. Change the cable with mono connector to DX8.
2. Use the Interface Adapter came with the package (I tried it before bought the cable, but didn't work).

Thanks for the response.
Old Mar 02, 2013, 01:23 PM
balf00r is offline
Find More Posts by balf00r
Registered User

Easyfly3 with dx8

Had problem with software finding radio. Finally ended up with Spektrum Trainer cable - 2 pole 3.5mm jack in radio and other end with reducer to 2.5mm 3 pole jack plugged into adapter using 3 core servo type connector. Works OK

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
New Product Spektrum DX8 & DX10 dman69 Radios 24567 Nov 26, 2016 03:20 PM
Yippee! New horizon hobby spectrum dx8!!!!!!!!! lightspeeddud Radios 1552 Oct 11, 2016 05:52 PM
Discussion AFPD/Easyfly3 compatabiliy clintski Simulators 1 Feb 27, 2009 09:45 PM
Discussion EasyFly3 Compared To Clearview? floridax Simulators 0 Oct 06, 2008 01:15 PM
Discussion Ikarus EasyFly3 456 Simulators 1 May 10, 2008 01:22 PM