Originally Posted by jombo
yep i still do , the problem i am having right now is in rate mode it is pretty solid and i get no drift. in HH mode with the red light on i still get a little tail wag/ drift . i have been reading about this problem and it seems to be with the tail blades being too long by 3mm, and the servo set at 3 to 5 mm from the center screw. since my pinion on the 250 came loose and i red loctited it yesterday i am going to try the tail servo first at 5 mm from center first. if i still get some wag then i may cut my tail blades down a mm at a time . the other solution was to lower the throttle curve , i did that but it flew ok but to hover i was almost at full throttle . i also want to change my tail blades to the K/B dream design 250 blades , that also will help .
jombo: you get two tailblades with the 250. The batman and the rectangular one. Try with the rectangular one, but sand the leading edge part to be flat. Try to make an even sanding on both sides. I'm using that on my plastic 250, and it had no wag, with the mystery gyrd gyro and esky 8g servo. The only problem that I get is initialisation every now and then, for which i perform the flick switch gear trick x3, and that temporarily fixes my problem other than that, no bounce. Also do you have a tacho? Try to see if you can tach your heli for your HS, at 100% and one at 85%, if none of this works, just wait for the new mems gyro from assan($15 and it's only 8g!!). I am so glad to see the fbl taking a big market in the heli industry, it's definately driving the prices down for these gyros.