help with skyartec wasp v3 - RC Groups
Thread Tools
Sep 26, 2010, 06:19 AM
Registered User

help with skyartec wasp v3

I have this wasp v3 and after setting it up it wants to go sideways, i have trimmed it up on the control but then it wants to fall over in the other direction when i apply power.
I am at a loss to work this out. PS I am a complete Newbe to Heli's.

Sign up now
to remove ads between posts
Sep 26, 2010, 10:37 AM
Cranky old fart
Balr14's Avatar
You must level the swashplate, level the servo arms, set the blade pitch and tail pitch, first. You also should make sure all screws are tight and preferably have locktite on the metal-to-metal ones. Aside from that, if it seems like trying to balance a golf ball on a basketball, then it's behaving quite normally. You picked a pretty difficult heli to start with.
Sep 26, 2010, 04:06 PM
Fly Runaway Fans
See above. They all go sideways when first losing contact with the ground. If you trim that out, they will go sideways the other way once above 18".

Quick Reply

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! Skyartec Wasp V3 - no rudder authority cfanto Beginner Training Area (Heli-Electric) 2 Apr 11, 2010 01:57 AM
Sold Skyartec Wasp V3 CP RTF CHEAP and Good to Fly! mygsx Aircraft - Electric - Helis (FS/W) 8 Nov 19, 2009 04:44 AM
Mini-HowTo Upgrading Skyartec Wasp V3 FP to V3 CCPM skyartec-usa Skyartec 0 Jun 27, 2009 04:40 PM
Sold Skyartec WASP V3 6CH PRO "kinda" RTF with spares 120deg CCPM w/ BROKEN TX HighNear90 Aircraft - Electric - Helis (FS/W) 23 Apr 28, 2008 04:11 PM
Discussion honey bee fp or skyartec wasp v3 fp with brushless and belt drive quadracer111 Micro Helis 3 Mar 17, 2008 05:10 AM