Thread Tools
Sep 21, 2010, 06:50 PM
Plane Destroyer / Life Enjoyer
airbagit13's Avatar
Discussion

Whats your favorite small Wing set up?


I have tons of lower KV motors for all my 3d models that use large props which I have been using on my home made wings and jets. I am limited to what jets I can build because I have to swing a large prop to compensate for the low KV.

I am going to be making a purchase from HobbyKing and was wondering if anyone has any suggestions for a motor. It will be used on home made EPP and Blucore jets and wings.

What are your favorite set ups for this kind of application.

I want speed and power!!! lol

Thanks in advance for the advice.
Sign up now
to remove ads between posts
Sep 21, 2010, 07:43 PM
Registered User
matyou's Avatar
get the hxt 2300kv motor on 3S
Sep 21, 2010, 10:25 PM
Plane Destroyer / Life Enjoyer
airbagit13's Avatar
What size prop do you swing on that so I can pick some up as well.
Sep 21, 2010, 11:02 PM
Registered User
matyou's Avatar
Get a 5x4.3 prop with a 10amp SS esc. I would also get a 610mah 3 cell and something in the same capacity range 2 cell. I used that setup on a 24in wing and it went straight up on 3cell. Dont go WOT with the 3cell for to long cause the motor does heat up. Also on 2 cell the 5x4.3 prop does really well so you dont have to change props.
Sep 22, 2010, 09:22 AM
Plane Destroyer / Life Enjoyer
airbagit13's Avatar
That motor is out of stock, any other suggestions?
Last edited by airbagit13; Sep 22, 2010 at 10:25 AM.
Sep 22, 2010, 10:22 AM
Registered User
matyou's Avatar
here is the link, unfortunately its not in stock.


http://hobbyking.com/hobbyking/store...idProduct=8478
Sep 22, 2010, 12:07 PM
Registered User

Another nice one


Check this out http://hobbyking.com/hobbyking/store...idProduct=5453
Edwin
Sep 22, 2010, 01:37 PM
Registered User
matyou's Avatar
I also have the 3000KV motor but still prefer the 2300kv because the 3000KV requires a bigger battery and lots of amps. This means that the wingloading of my 24inch wing went so high that it was hard to control. Besides, the glide rate went down as well.
Sep 22, 2010, 02:50 PM
Plane Destroyer / Life Enjoyer
airbagit13's Avatar
I went ahead and ordered that 3000 kv one to try out.I ordered the small 2300 kv turnigy motor as well just to mess with.

I will pair that Turnigy with the HK 10a esc and the Hextronic Motor with a 30a ESC.

I will be using either 800 mah 3s or 800 mah 2s with it so I picked up 5x4.3 props and 4x4 or something like that.
Sep 22, 2010, 04:23 PM
Registered User
I have a couple of these. The 2100Kv will do 6x3 on 3s or 7x3.5 on 2s. Noisy, but tough.

http://hobbyking.com/hobbyking/store...cro_Motor_(19g)
Sep 23, 2010, 01:29 AM
Registered User
gjalbert's Avatar
Quote:
Originally Posted by matyou View Post
here is the link, unfortunately its not in stock.


http://hobbyking.com/hobbyking/store...idProduct=8478
This is essentially the same motor and is in stock.

http://www.hobbyking.com/hobbyking/s...idproduct=8140

Gary
Sep 23, 2010, 01:20 PM
Plane Destroyer / Life Enjoyer
airbagit13's Avatar
Yeah I ordered that one, I like Turnigy to.

I have quite a few Turnigy motors and none of them give me any problems. I actually think my Axi 2212/26 equivalent is even better then my Axi 2212/26.
Sep 23, 2010, 02:37 PM
Registered User
Ace12GA's Avatar
This is my fave on both 2s and 3s: http://www.hobbyking.com/hobbyking/s...idProduct=5208


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Whats your favorite windy weather plane? Captain Bravo Foamies (Scratchbuilt) 34 Apr 12, 2010 04:54 PM
Discussion Whats your favorite plane? joshuablume Electric Plane Talk 28 Mar 04, 2010 04:22 PM
Discussion Opinions needed, whats your favorite plane for learning LT stick rudder? Jimmy JFlyer Foamies (Scratchbuilt) 22 Jan 21, 2010 08:07 AM
Discussion Whats your favorite brushless motor? adbradley Power Systems 36 Nov 14, 2009 08:50 AM
Discussion what's your favorite 3D foamie and set-up? rednote Foamies (Kits) 1 Oct 30, 2007 11:37 AM