Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Sep 19, 2010, 10:45 AM
EuroDriver is offline
Find More Posts by EuroDriver
Registered User

Multiplex Cockpit SX 2.4 GHz Model Memory Lost

The unit has a manufacturing date of 09/09. I programmed a Arcus sport in Mode 6 back in October 2009, and then programmed a new FVK Graphite 2 full house in Mode 6 during the last 3 weeks

Battery was at 7.34 v and I did the full setup and then charged the battery at 100 mA for about 5 hours. Battery now reads 8.21v. The bummer is after charging the battery, the saved settings for the Graphite 2 have completly disapeared, everything, name, model type the works. The saved settings for the Arcus are still there

The only unusual thing I did was to use a Graupner cell tester to check the voltage of the Tx battery. With the Tx in the off position, I first connected the charging cable to the LiPo contacts, got a silly reading and then plugged it into the Rx battery slot and got another silly reading. Hard to imagine that would reset the current / active model memory

I see that in 2008 MPX had some problems with the previous SX model

Has any one expeienced something similar with the 2.4 GHz SX ?

Calling Multiplex in Germany tomorrow. I really liked the ergonomics and programming, but now to put it mildly I am scared to fly with this Tx in my not inexpensive G2
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Cockpit sx set up ( not 2.4 ) mrdoodah Hand Launch 14 Sep 20, 2010 04:35 PM
Discussion MPX Cockpit SX converting to Corona 2.4 GHz guide. KOF DIY Electronics 0 May 11, 2010 07:40 AM
Discussion What about Multiplex Cockpit SX 2.4 - native 2.4 radio cornel4web Radios 1 Oct 11, 2009 05:03 AM
Mini-Review SPEKTRUM 2.4 GHz on Multiplex Radio (ROYAlevo, Cockpit SX) FASTGLIDING Radios 5 Jun 11, 2009 04:08 AM
Discussion Corona 2.4 for Multiplex Cockpit SX almtmd Radios 3 Jan 26, 2009 03:03 PM