Shop our Airplanes Products Drone Products Sales
Thread Tools
Jul 03, 2011, 03:22 PM
Registered User
Tamjets's Avatar
Jim,
Base on what you got....I would said you be at 6.1-6.3 lbs dry if you really skin the Habu.
My P-20 Habu weight 6.9 lbs and had use dual 900mAh lipos Rx and 2100mAh for ECU(needed for nose weight to balance). I was trying to save weight by tap the power from ECU..But Jetcat told me not too. The ECU away feed some bad RF noise to RX if tap the power ECU. So be safe than sorry with extra 4 oz for MPI voltage regulator and dual 900mAh 7.4v lipos.


BTW,
Just done flying and now ready for July 4th party....
Now I'm offcial off for the weeken.
Last edited by Tamjets; Jul 03, 2011 at 03:39 PM.
Sign up now
to remove ads between posts
Jul 03, 2011, 06:20 PM
Xtreme Power Systems
ACK! That's heavy. I will have to weigh a stock plane without electronics to determine what that weight is. Maybe I will use fixed gear.
Jul 03, 2011, 07:19 PM
Registered User
Tamjets's Avatar
Quote:
Originally Posted by JimDrew
ACK! That's heavy. I will have to weigh a stock plane without electronics to determine what that weight is. Maybe I will use fixed gear.
Fix gear not go to save you much.
The fuse is the most heavy of all. My 1:12 F16 is lighter and you got an idea.
Jul 03, 2011, 07:28 PM
Registered User
Quote:
Originally Posted by JimDrew
ACK! That's heavy. I will have to weigh a stock plane without electronics to determine what that weight is. Maybe I will use fixed gear.
Hmm, a turbine sport jet with fixed gear? Whats the point? BTW The difference in weight between fixed gear and eflight retracts is barely anything. I dont think there is that many ways you could lighten the stock habu airframe without losing strength? The fuse does feel pretty bulky but I think its in the layup of the glass. Good luck!
Jul 03, 2011, 09:53 PM
Registered User
bri6672's Avatar
Nice, a guy with 18 posts is taunting Jim Drew, this should be good.
Jul 03, 2011, 09:57 PM
Registered User
ZACATTACK's Avatar

Tam Struts


I ordered the maintainence kit from Tam.What modifications do you need to do to these struts to fit the factory skirts on it..Any drilling or tapping?? Thanx!!
Jul 03, 2011, 10:38 PM
Lithium Member
Herb's Avatar
Lots of EDF flying today in the nice cool ocean breezes ... Some HD video of Bruce's nice Habu 32 flying on 7S in a bit.

.

Fastest E-Flite Habu 32 - 7S Power (HD) (5 min 18 sec)
Last edited by Herb; Jul 04, 2011 at 02:28 AM.
Jul 04, 2011, 12:19 AM
SoCal, Year Round Flying!
bmiller's Avatar
Thanks Herb!
Jul 04, 2011, 04:53 AM
Registered User
hypstar's Avatar
"So, finally maidened my AC. It is among the fastest Ive ever tried. This is with stock setup. Pretty hard to get the photograph to get it on picture."
Sincerely
Marcus

Marcus,I take it that your maiden was a success,Congrats! Nice picts.

//Andy.
Jul 04, 2011, 08:52 AM
Registered User
Quote:
Originally Posted by bri6672
Nice, a guy with 18 posts is taunting Jim Drew, this should be good.
I wasnt trying to start anything with anyone, sorry if I sounded a bit sarcastic. However,be careful not to judge people by how many "post" they have either. Ive been building jets for over 20 years with my dad. Back then we had A4's and kfirs from Larry Wolfe(JHH) and had to fly them with k&b .45's and turbax fans. That was the best there was at one time. We had no internet.
Jul 04, 2011, 09:58 AM
More jets than a carburetor
skydve76's Avatar
man you guys are crazy for flying with sun in your face, ive never been able to do that
Jul 04, 2011, 10:18 AM
Registered User
Herb, Great flying! How are the motor temps on 7s btw?
Jul 04, 2011, 11:19 AM
SoCal, Year Round Flying!
bmiller's Avatar
I've learned to fly around the sun! Go over or under with good sunglasses!
The bullet fairing on the stock fan blocks our temp guns so no idea on motor temps
except it's probably very hot! I'll do a fast pass then cool it down under 1/2 throttle
then after landing keep it running at low power for a minute or so. Usually the taxi back to the pits is enough.
Jul 04, 2011, 01:19 PM
Registered User
bri6672's Avatar
Quote:
Originally Posted by Boothcj
I wasnt trying to start anything with anyone, sorry if I sounded a bit sarcastic. However,be careful not to judge people by how many "post" they have either. Ive been building jets for over 20 years with my dad. Back then we had A4's and kfirs from Larry Wolfe(JHH) and had to fly them with k&b .45's and turbax fans. That was the best there was at one time. We had no internet.
Not doubting your knowledge of the hobby but knowledge of the forum members, if someone is going to find away to make it work Jim Drew is on that list. That's cool u have experience with jhh they are awesome models!


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Fiberglass Habu Airframe Calvin_220 Electric Ducted Fan Jet Talk 92 Nov 10, 2012 02:53 AM
Sold New in box Habu EDF PNP flyboy1945 Aircraft - Electric - Jets (FS/W) 2 Aug 01, 2010 08:24 PM
Discussion ESC very HOT - Sorry the discussion is moved to the Habu thread SalamSyed Foamy EDFs 0 Mar 20, 2010 11:15 PM
New Product New Fiberglass EDF Jets!!! Starfire + EDF Trainer nitroplanes Nitro Planes 0 Jan 24, 2009 09:58 AM
Discussion Baja SS Speculation and hopup thread. DaveESPI Large Scale Cars 3 Feb 03, 2008 07:39 PM