Anyone tried the BlitzRCWorks MX2 Pro 3D? - RC Groups
Thread Tools
Sep 08, 2010, 07:02 AM
Foam shredder
HallaBalla's Avatar

Anyone tried the BlitzRCWorks MX2 Pro 3D?

Found it on

I'm considering graduating from my Cessna-type high wing foamies, and I wonder if this model might be worth a try.

Anyone tried it? How is the build quality, performance, ruggedness, ease of flying etc? Thanks in advance.
Sign up now
to remove ads between posts
Jul 01, 2011, 09:09 PM
Registered User
p901P901's Avatar
The one I received, the ESC did not work. After the first flight the elevator hinge broke and the aileron hinges where so loose that I could move them up and down 1/4" at the leading edge. I replaced the rudder and elevator hinges with Robart 1/8 hinge points and the ailerons with 3/16 robarts. On the ailerons you have to insert a block of wood into where the old hinge points where to stiffen this area up. Also if you plan on some high speed maneuvers you must stiffen the wing up with a carbon fiber rod or the wings will flex.
I replaced the ESC with a 30A Volcano Series from Hobby Partz and static amps is 35 amps at full throttle with a 13 x 4 APC prop. So far the motor is holding up and using the APC prop performs much better than the stock prop.
After all these mods the plane response is better but its not an real good 3D plane.
Mar 26, 2012, 09:16 AM
Registered User
Sorry wrong place
Last edited by superredeye; Mar 26, 2012 at 09:18 AM. Reason: Incorrect

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion KDS Flymentor 3D has anyone tried one Flying Barry 3D Electric Heli Flying 8 Dec 26, 2011 08:09 AM
Discussion BlitzRCWorks Tornado 3D vs. Blade SR RTF Tinytacohead 3D Electric Heli Flying 15 May 19, 2011 01:35 AM
Discussion Anyone tried Mia or Zulu Canopies? shastamike Micro Helis 23 Aug 10, 2010 11:11 AM
Discussion Anyone tried 3D features of FMA Co-pilot II DominicM 3D Flying 0 Feb 12, 2010 03:09 PM
Discussion Anyone tried the BlitzRCWorks F-86 Sabre cutty01 Foamy EDFs 33 Sep 23, 2009 05:02 PM