Futaba 10CG - problem with end point adjustment
Not too long ago, I got a new Futaba 10CG from eBay. Right now I am setting up my MPX Easy Glider Pro. I noticed a strange behaviour of my radio - when I am adjusting the end points, the neutral points of the servos also change! For example, when I was setting up the elevator deflections to +/-63%, the elevator neutral point moved down when I was decreasing the upper end point (from 100%) and then moved up when I was decreasing the lower end point. All in all, the neutral point remained the same. But in case of ailerons, the neutral point changed, because I set up larger deflection up than down. As a result, using even ALL of my sub-trim can't help me with keeping my ailerons in line with the wing.
I have this plane in "Glider (1A+1F)" mode. Any comments?
Last edited by Szymon Bartus; Sep 02, 2010 at 05:28 AM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||DSX9 End Point Adjustment||spotterone||Radios||3||Apr 24, 2010 07:04 PM|
|Question||End Point Adjustment, Futaba 7C||agran1021||Beginner Training Area (Heli-Electric)||9||Jun 10, 2009 07:59 PM|
|Help!||End Point Servo Adjustment problem||piotrek||Radios||2||Jun 27, 2008 04:31 AM|
|FUTABA End Point Adjustment||DougC||Radios||2||Jun 01, 2005 04:50 PM|
|End point adjustment problem||mountain flyer||Parkflyers||3||Jun 20, 2003 07:01 PM|