 |
 |
 |
 |
|
|
|
|
|
One hour CD_ROM motor construction
This is CD ROM motor easy construcion without rewinding.
|
|
|
|
|
|
|
|
|
|
|
One hour CD_ROM motor construction
Change Y to Delta.
|
|
|
|
|
|
|
|
|
One hour CD_ROM motor construction
Just termination wiring change.
|
|
|
|
|
|
|
|
|
One hour CD_ROM motor construction
CA the prop shaft with PET 5mm nut for prop screw shaft.
|
|
|
Last edited by Takao Shimizu; Jun 23, 2003 at 07:44 AM.
|
|
|
|
|
|
One hour CD_ROM motor construction
Test result;
GWS 8043, 6V, 2.4A, Thrust 83g, 3720rpm |
|
|
|
|
|
|
|
|
One hour CD_ROM motor construction
This is the original Y termination.
|
|
|
|
|
|
|
|
|
Robbie d,
>is there a one hour convert your speed control to brushless speed control???? Not yet. |
|
|
|
|
|
|
|
|
More details
You may need motor mount cutting.
I use just hand powered cutter tool($7) and sand paper. |
|
|
|
|
|
|
|
|
More details
De-solder and de-twist at the Y coil connection point.
De-paint is usefule to nude-off the coil wire paint. |
|
|
|
|
|
|
|
|
Put on the plane.
|
|
|
|
|
|
|
|
|
Ready to test fly
You may need the timing adjust of ESC.
4A ESC is enough to drive this. |
|
|
|
|
|
|
|
Another ready to fly
I am also modifying the same CDROM motor. Only different way to mount on the plane. Ready to fly tomorrow.
YG-F1G Delta wind GWS 6x5SF 7.29V 2.25A 16.40W 5,520rpm rewound with 0.4mm 20T GWS 7x6SF 5.63V 5.86A 33.00W 4,010rpm GWS 6x5SF 6.10V 4.92A 30.00W 6,720rpm satoru |
|
|
|
