Vibration Comparison - RC Groups
Thread Tools
This thread is privately moderated by Heli Hacker, who may elect to delete unwanted replies.
Jul 13, 2010, 09:33 PM
Hang on, turbulence ahead
Heli Hacker's Avatar

Vibration Comparison

I took a vibration measurement today on the PhuBar3, similar to the one I did earlier on the PhuBar2. The amplitude of the vibration is somewhat higher on the PhuBar3, most likely because it is mounted differently, and not as isolated from the frame as the PhuBar 2 was.

This was done with the ITG-3200's built-in low-pass filtering set to 5hz. This is a much lower cutoff frequency than the software filter in the PhuBar2 which is set to 47hz. This is comparable to the software filter in the PhuBar2, which is set to 5.3hz

Just comparing the two visually, it looks like the impact on the servo control signal is comparable between the two devices.
Last edited by Heli Hacker; May 02, 2011 at 07:02 PM. Reason: Correction on PhuBar2 filter cutoff frequency
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion 4#3B and 4#3 V1 B/H Mod Response Comparison PLUS converting the 4#3B to a Speedster EQMOD Micro Helis 48 Oct 29, 2009 07:14 PM
Question Bird of Time comparison BDOG1 Sailplane Talk 21 Oct 18, 2009 09:34 AM
Discussion EDF mounting comparison lrb75 Electric Ducted Fan Jet Talk 1 Oct 07, 2009 12:55 PM
Mini-Review Airhogs Atom review and Micro Havoc Heli comparison all4smallrc Micro Ready-to-Fly 9 Sep 01, 2009 04:42 PM
Discussion Idea of making a Vibration sensor for measuring the Vibration of Helicopter? lazy-b DIY Electronics 12 Mar 06, 2008 12:36 AM