|
|
|
mine did not come with a Y harness for the esc's, what control wires are you talking about? the servos all had leads long enough to reach the receiver on my kit.
Kevin |
|
|
|
|
|
|
mine was a very late kit I am assuming, as mine came with all the linkages installed. I did not remove one of the red wires from the bec either, did not even think about it when I was doing all of the setup.
Kevin |
|
|
|
|
|
|
|
|
|
|
|
I found with mine that right out of the box, the fans were not clearing the shroud very well, so I had to go in with a Dremel and grind off just enough in those places where they touched. If one or both fans are not balanced, you can sometimes feel it as a vibration when you spin it up or you can hear odd harmonics. If you really want to be sure, then you have to take the fans out and check them on a prop balancer. But then, you won't know if the motors are balanced. To balance the whole assembly becomes a fairly complicated trial and error exercise. These are not terribly high rpm fans, so if they run pretty good at max throttle, just leave them. Besides making clearance for the fans, I did nothing else to them.
|
|
|
|
||
|
Quote:
Yes I did read here about the fan touching but it seemed to be normal and it should work itself out, but I will check to be sure. I had read about balancing the whole assembly and it seemed very tedious to say the least. I always check all my servos and motors (wattmeter) before doing any assembly of my aircraft. Thanks again for your assistance. |
|
|
||
|
|
|
|
|
|
|
|
|
This is the latest coupon code good till end of today
http://www.nitroplanescoupons.com/co...escoupons.html I'm trying to get a pic of my A10. I'ts now been passed to the 5th pilot and it's been through hell and back. Pilot #4 decided to run 4S with it. Its still a stock setup with added vent holes. |
|
|
|
|
|
|
|
|
|
||
|
Quote:
Russ |
|
|
||
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | Nitroplanes Brushless A-10 uneven motor light off help | JettaManDan | Foamy EDFs | 2 | Aug 07, 2010 08:50 AM |
Help! | NitroPlanes A-10 Thunderbolt Brushless LiPo Battery / EDF Problem | ISNJH | Electric Plane Talk | 13 | May 12, 2010 07:56 PM |
Discussion | NitroPlanes A-10 Brushless EDF Initial Thoughts | JettaManDan | Foamy EDFs | 1 | Apr 28, 2010 07:41 AM |
Video | Nitroplanes OV-10 with Flycam one | chevronflyer | Electric Plane Talk | 3 | Apr 12, 2010 08:03 AM |
Discussion | Another A-10 conversion and Nitroplanes Warthog | mal818 | Foamy EDFs | 8 | Sep 14, 2009 01:08 AM |