Program Flaperons Using T6A Radio - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
May 16, 2010, 07:32 PM
Say watt?!
killerwin's Avatar

Program Flaperons Using T6A Radio

Here's how I programmed flaperons with my T6A radio.

I started out with a servo on CH1 for the left aileron and a servo on CH6 for the right aileron. I programmed the first mix (MIX1) for standard ailerons as follows:

Mix Num: MIX 1
Source: CH1
Des: CH6
Up Rate: 100%
Down Rate: 100%
Switch: ON
If all you want is ailerons, this is where you can stop. Next, for flapperons, I used up the remaining mixes (MIX2 & MIX3). MIX2 for CH1 (Left Aileron) and MIX3 for CH6 (Right Aileron):

Mix Num: MIX 2
Source: VR B
Des: CH1
Up Rate: 75%
Down Rate: 75%
Switch: SW B
Mix Num: MIX 3
Source: VR B
Des: CH6
Up Rate: -75%
Down Rate: -75%%
Switch: SW B
This results in the ability to switch flaperons ON and OFF with Switch B (SW B) and adjust the angle of the flaperons by rotating Pot B (VR B).

There are many options and settings to play with here, including aileron differential; to read further, see the thread where I found the info I needed:

Here’s the video:

How to Program Flaperons Using T6A Radio (4 min 39 sec)
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion New software for the HobbyKing HK-T6A, FlySky FS-CT6A and Turborix TBXT6 radio HappyMan2009 Radios 487 Sep 13, 2017 04:21 AM
Discussion Radio 2.4 Ghz HK-T6A (Hobby King) 6 canais nino_sdk Brazil 93 Jul 06, 2012 03:40 PM
Discussion Anyone using HK T6A??? spessx Mini Helis 0 Dec 28, 2009 07:21 PM
Sold Hobbyking T6A 2.4ghz 6ch Radio System with extras whitty7628 Aircraft - General - Radio Equipment (FS/W) 1 Sep 29, 2009 09:16 PM
Discussion flaperons+flaps program 9 zap videocruzer Radios 2 Sep 04, 2009 01:18 PM