New Board! - RC Groups
Thread Tools
This thread is privately moderated by Heli Hacker, who may elect to delete unwanted replies.
May 16, 2010, 03:08 PM
Hang on, turbulence ahead
Heli Hacker's Avatar

New Board!

Finished board design for PhuBar 3 using ITG3200 3-axis gyro. Managed to squeeze the board size down to 30x28mm. If I solder cables directly onto the board instead of headers, and use clear shrink wrap instead of an enclosure, the whole thing should be 30x28x7mm, except for where the 5-pin programming connector will stick out from one side.

I added the fifth pin to that connector to supply 3.3v so I can use the TextStar serial terminal for field setup.

I also added connector pads for 2 general-purpose I/O connections plus ground to allow for programming the Propeller to do other functions if desired.

The 3-axis gyro will let me add rudder gyro capability, as well as use cosine-matrix math for more accurate attitude estimation.

Update: I received the boards from BatchPCB on June 1. They look really good - photo below
Last edited by Heli Hacker; Aug 26, 2010 at 10:18 PM.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion New to the board, could use some help. timmins02 Lagoon Valley Electric Flyers 6 Mar 06, 2010 02:31 PM
For Sale (2) Chargery 550B 5s 5A Like new with JST-XH balance board Zeta Phoenix Aircraft - Electric - Batteries & Chargers (FS/W) 8 Dec 12, 2009 02:11 AM
Discussion new aerobat on the drawing board Conwy-Soarer Foamies (Scratchbuilt) 0 Nov 03, 2009 07:39 AM
Sold K&B 3.5 out board new clif Boats (FS/W) 6 Nov 02, 2009 07:29 PM