| Thread Tools |
| This thread is privately moderated by Sandancer, who may elect to delete unwanted replies. |
|
|
|
Thread OP
|
Build Log
P-51D: Servo Tray
Servo Tray
I built a tray out of 3/32" Birch ply as I didn't trust that the foam would handle the torque the elevator would put on the servo. NOTE: I am using the HiTech HS-82MG servo for the elevator, and the Hextronic MG-14 for the rudder/DSR steered tail wheel. ImagesView all Images in thread
|
|
|
Last edited by Sandancer; Sep 18, 2010 at 09:06 AM.
|
|
|
|
