P-51D: Servo Tray - RC Groups
Thread Tools
This thread is privately moderated by Sandancer, who may elect to delete unwanted replies.
May 06, 2010, 10:57 PM
"Auntie Samantha"
Sandancer's Avatar
Build Log

P-51D: Servo Tray

Servo Tray

I built a tray out of 3/32" Birch ply as I didn't trust that the foam would handle the torque the elevator would put on the servo.

NOTE: I am using the HiTech HS-82MG servo for the elevator, and the Hextronic MG-14 for the rudder/DSR steered tail wheel.
Last edited by Sandancer; Sep 18, 2010 at 10:06 AM.
Sign up now
to remove ads between posts

Thread Tools