Thread Tools
Old Mar 20, 2010, 12:05 PM
feefo is offline
Find More Posts by feefo
#who gives a rats a**?
feefo's Avatar
Discussion

Servo reversing Y leads & Spektrum


I plan on using a servo reversing y lead in a full house sailplane due to using a Dx6i and not being able to reverse 1 of the flap servo's. I can't turn the servo around as this was a 2nd hand kit and the work has been done for the flaps. I presume there's no prob using this type of lead with Spektrum? I'll be using a seperate 6v rx pack.
Sign up now
to remove ads between posts
Old Mar 20, 2010, 01:11 PM
ebill3 is offline
Find More Posts by ebill3
Registered User
ebill3's Avatar
I have no personal experience, but see the Don't recommendation from Spektrum. Hopefully others may have direct knowledge.

Bill
Old Mar 21, 2010, 05:54 PM
feefo is offline
Find More Posts by feefo
#who gives a rats a**?
feefo's Avatar
Bummer....'Don't use a servo reversing y lead'.

Cheers for the link, saved me a few hundred there mate

Guess the TX I'd been spying to do a full house sailplane justice has just jumped the que. At least the Mrs won't notice that hanging in the garage.
Old Mar 21, 2010, 06:20 PM
Wingman26 is offline
Find More Posts by Wingman26
Registered User
Wingman26's Avatar
This may not be the answer you're looking for, but here's one way to do it:

If you use digital servos you can use a servo programmer to reverse one.

I can also tell you what I did when I needed 2 elevator servos for a quarter scale and had a DX6i....I bought a DX7, which has that capability.
Old Mar 21, 2010, 06:23 PM
pmackenzie is offline
Find More Posts by pmackenzie
I don't want to "Switch Now"
pmackenzie's Avatar
I can't see how a servo reverser would make any difference, Spektrum or not.

All it does is read in the servo signal and then send it out again in an altered form, not unlike a gyro. And gyros work fine.

But as an excuse to buy a better radio - it is as good a reason as any

Pat MacKenzie
RCG Plus Member
Old Mar 21, 2010, 06:30 PM
Miami Mike is online now
Find More Posts by Miami Mike
Registered Taranis User
Miami Mike's Avatar
Here's an Ebay vendor who claims his servo reverser will work with a Spektrum system. However, the same reverser is also sold by Tower Hobbies and they don't make that claim. Also, some of the guys in this thread say they've been using them in giant scale planes with no problems.

I suspect that Horizon Hobby isn't really sure about the question and are playing it safe. The only reason I can think of for it not working is if you're using higher voltage than the servo reverser can tolerate. Perhaps Horizon Hobby will eventually offer a reverser than they'll market as being "approved for Spektrum systems".
RCG Plus Member
Old Mar 21, 2010, 06:40 PM
feefo is offline
Find More Posts by feefo
#who gives a rats a**?
feefo's Avatar
Hmmm, not sure why you can't use them either really, I was going to use a 6v rx pack, so voltage drop off shouldn't be a concern, IF that could be a problem and it certainly shouldn't be interference.

I originally wanted the DX7 but get the impression it won't do what I'm after. Posted on this before and got loads of good (but expensive) advice. Now looking at a 9ch.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale Servo Sense Plus and Reversing Y Harness Twmaster Aircraft - General - Radio Equipment (FS/W) 5 Jan 06, 2010 04:06 PM
Sold REVERSING Y and a SERVO SLOWER dumbdidgits Aircraft - General - Radio Equipment (FS/W) 1 Dec 11, 2009 10:12 PM
Wanted Servo reversing y connector Dennis Everett Aircraft - General - Radio Equipment (FS/W) 2 Nov 30, 2009 11:43 PM
Question Servo Y leads Silvermane Radios 3 Sep 17, 2009 03:30 PM