Thread Tools
Old Apr 15, 2010, 09:45 PM
Cralis is offline
Find More Posts by Cralis
I love FPV!
Cralis's Avatar
Daniel, any opinion on this question I asked?

Thanks,
Craig
Sign up now
to remove ads between posts
Old Apr 15, 2010, 09:46 PM
Dialfonzo is offline
Find More Posts by Dialfonzo
DiaLFonZo - UAV/Drone
Dialfonzo's Avatar

Tanks a lot


Daniel Wee

Look like you modification have work.

http://helifreak.com/album.php?albumid=4620

Now i need to make the gps work..
RCG Plus Member
Old Apr 15, 2010, 09:54 PM
plesk is offline
Find More Posts by plesk
Registered User
plesk's Avatar
Daniel,
OK. Now I get it work. Sorry
plesk
Last edited by plesk; Apr 15, 2010 at 10:14 PM. Reason: OK. Now I get it work. Sorry
Old Apr 15, 2010, 10:36 PM
Daniel Wee is offline
Find More Posts by Daniel Wee
Registered User
Cralis,

Not at the moment. The problem is we just don't have the funds to put into stocking up on GPS modules and current sensors. However, I think if you make a special request to John, he should be able to help you out with this. I just don't think we can offer this on a large scale.

Dialfonzo,

Another thing you can try, instead of the above modifcation, try inserting a single 75ohm resistor in the camera video line to the OSD (in series). You may, or may not need the capacitor but if this works, you won't need the 220ohm resistor.

Daniel
Old Apr 15, 2010, 10:50 PM
Dialfonzo is offline
Find More Posts by Dialfonzo
DiaLFonZo - UAV/Drone
Dialfonzo's Avatar

Will Try


Daniel Wee

Tanks i will try it that way.

BTW i have the GPS aquired



I have play with X and Y to make lettering fit.

Do it have a way to play with the size of the letterig ?
RCG Plus Member
Old Apr 15, 2010, 10:52 PM
Dialfonzo is offline
Find More Posts by Dialfonzo
DiaLFonZo - UAV/Drone
Dialfonzo's Avatar

Forgot something


The information on the left:
Peak Value...

Is popping and disapear all the time. Is it normal ?
RCG Plus Member
Old Apr 15, 2010, 11:08 PM
mark hitchman is offline
Find More Posts by mark hitchman
Zephyr 66" Blunt
mark hitchman's Avatar

DOSD+ flight


Not much to see really, just flew arounf home. Plane is too heavy now with camera and about a kilometer of wiring that I haven't sorted yet. Shows AHI working but not much else. Tomorrow I will put gear into a glider that will fly smoother. End of video is picture of the plane, it's what I use to crash test

Dosd+ firmware 1.6e extra 300 800mm wingspan foamy (5 min 5 sec)


Mark
Old Apr 16, 2010, 12:57 AM
barok is offline
Find More Posts by barok
Registered User
barok's Avatar
hi dialfonzo.. have the same rx..nice mod..neat.. just wondering? why do you not have a 5v line in the ppm? and the rssi, signal and ground only.. omit the middle pin (3.3v) on the osd...
http://helifreak.com/picture.php?alb...ictureid=35760
Old Apr 16, 2010, 01:09 AM
mark hitchman is offline
Find More Posts by mark hitchman
Zephyr 66" Blunt
mark hitchman's Avatar
Hi Daniel, 6.1f looks good, not have time to upload vid now, autopilot and IMU be all working sweet soon with the speed you bring out the changes.

Thanks

Mark
Old Apr 16, 2010, 03:33 AM
Daniel Wee is offline
Find More Posts by Daniel Wee
Registered User
Dialfonzo,

No, you cannot change the font size. You can however select a display screen with smaller fonts. Try setting OSD mode to 2 and you should see smaller fonts if that's what you're after.

The peak values will only show up if your speed indicates that you have stopped flying, usually. Sometimes it can show up if you are flying into the wind such that the ground speed is zero. GPS fluctuations while stationary can also cause the display to pop on/off depending on how stable your GPS position fix is.

mark,

WOW!!! 1.6e did real well. I think you will like 1.6f more though. For sustained turns, I would expect 1.6f to perform much better but it's a lot of tweaking.

Daniel
Old Apr 16, 2010, 03:49 AM
JMSTECH is offline
Find More Posts by JMSTECH
Registered User
JMSTECH's Avatar
Mark:

I can't get over how well that version worked out for you!!! Love your play ground... you lucky MAN!

John
Old Apr 16, 2010, 04:53 AM
plesk is offline
Find More Posts by plesk
Registered User
plesk's Avatar

JR PCM RS10DS Receiver


Daniel,

I have found the PCM RS10DS RSSI signal and now DOSD+ can show the RSSI value.

plesk
Old Apr 16, 2010, 06:51 AM
jimbob00 is offline
Find More Posts by jimbob00
Registered User
excellent results for this imu video

you should try rolls and loopings, there seemed to be something wrong about it on jettiplot's video (imu not going back exactly on the horizon)
Old Apr 16, 2010, 09:05 AM
Daniel Wee is offline
Find More Posts by Daniel Wee
Registered User
JettPilot was using an earlier version of the IMU code. Mark is using a newer one with improvements. 1.6f should be even further improved.

Daniel
Old Apr 16, 2010, 09:16 AM
jimbob00 is offline
Find More Posts by jimbob00
Registered User
no worries, given the results i have no doubt you will have it perfect overtime, still would be good to roll it around a bit so we know it's fixed/working. at least, on my side the only idea i can have of how well it's working is the videos ppl post here.

i have already ordered the imu you guys are using (and the baro from dyidrones) too due to these good results anyway so i can check by myself too soon i hope :P


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Dragon OSD Level Flight FPV Talk 22 Dec 31, 2013 09:08 PM
For Sale New Intelligent Flight Dragon OSD bfischer Aircraft - General - Miscellaneous (FS/W) 7 Jul 19, 2010 12:56 PM
Discussion FS Ready to fly Intelligent Flight Dragon OSD bfischer FPV Talk 0 Mar 03, 2010 06:57 AM
Discussion RV OSD or Dragon OSD djdaveq FPV Talk 1 Feb 06, 2009 01:18 AM
Discussion RV OSD and Dragon OSD - so near to being Really good! magnetman FPV Talk 8 Nov 11, 2008 06:13 AM