What speed do you think i could get with this?
https://www.hobbyking.com/hobbyking/s...idProduct=9083

and

https://www.hobbyking.com/hobbyking/s...ontroller.html
And
Sky lipo 3300mah 3s 40c lipo?
I do not know what prop i should get. Do you have a recomendation for a pretty cheap setup capable of 120?

Those links don't work....not for me anyway.

Oops sorry. Let me try again.
https://www.hobbyking.com/hobbyking/s...ontroller.html
https://www.hobbyking.com/hobbyking/s...idProduct=9083

Ok I really am ready to buy a motor:
Here are some of the equipment I have:

CC Ice 100 ESC
60 amp Turnigy ESC

Batts
4s 2200
3s 3350
4s 3300
3s 2200

I am wanting to getting speeds over 120 without mods. What motor should I get and use any of the above equipment? Should I get a whole new setup what should I get
Thanks

Hey guys I am totally new to whole FJU realm and I am currently having a problem with the spinner. Under load it seems the rotor pulls into the motor and the prop will strike the mount plate screws. The instructions are useless so I am asking if there is a correct way to install the motor, spinner and plate? I'd imagine I would need to find the right amount of clearance for setting the spinner but I don't think it should be hanging on the edge of the motor shaft. Any thoughts guys?

Originally Posted by zeus3313

Ok I really am ready to buy a motor:
Here are some of the equipment I have:

CC Ice 100 ESC
60 amp Turnigy ESC

Batts
4s 2200
3s 3350
4s 3300
3s 2200

I am wanting to getting speeds over 120 without mods. What motor should I get and use any of the above equipment? Should I get a whole new setup what should I get
Thanks

You can definitely do it with those parts. I ran a HET 2w-23 with a 5.2x5.2 on 4s and got around 130mph flat and level, 140+ in a dive. Pulls about 85 amps static if I recall correctly.

How much does a funjet weigh? Whats a good weight to thrust ratio with one of these planes? Thanks

Where's the best place to buy a Funjet these days? Are they discontinued? Love my X-83 and that is discontinued and would love to replace it with a funjet when she dies.

http://www.rctoys.com/email/BlackFriday.html

Originally Posted by jasonafriedman

http://www.rctoys.com/email/BlackFriday.html

Geez thanks but that is 3x cost a x-83, damn it should have bought a few of the x-83 a while back .

I was getting about 105A static on 4S and a 7.4X8. Considering you'' get about a 10% drop in flight this prop will be fine on 5S. Maybe even a 7X10 if you're carefull.
With 4S and 7.4X8 the motor was barely warm - plenty potential left.
BTW - I got 194mph on that set up (down wind with a dive). If didn't ever do a level flight test but I reckon its about 175mph.

Originally Posted by nofreee

I'm going with a 5s setup and plan on starting with a APC electric 7x6 and going from there, maybe a 6x5.5 depending how many amps it pulls.

I put the 4s batts in to see what it would take to get the CG right. The 5s 3000mah are about 150g heavier than the 4s, so it should help with the balance.

Originally Posted by War Machine

I was getting about 105A static on 4S and a 7.4X8. Considering you'' get about a 10% drop in flight this prop will be fine on 5S. Maybe even a 7X10 if you're carefull.
With 4S and 7.4X8 the motor was barely warm - plenty potential left.
BTW - I got 194mph on that set up (down wind with a dive). If didn't ever do a level flight test but I reckon its about 175mph.

Good to know. I've got a CC 100a that's going in there. I'm only shooting for around 160mph or so initially, then I'll prop up from there.

Originally Posted by jasonafriedman

Oops sorry. Let me try again.
https://www.hobbyking.com/hobbyking/s...ontroller.html
https://www.hobbyking.com/hobbyking/s...idProduct=9083

KV of that motor is a bit high, might be ok on 3s and the quoted 5.5x4.5 prop but as it's been said bigger props are better. Pretty sure it'll work, just don't think it's 'ideal'.

Always found Turnigy esc's to be ok (good value for money)

Originally Posted by zeus3313

Ok I really am ready to buy a motor:
Here are some of the equipment I have:

CC Ice 100 ESC
60 amp Turnigy ESC

Batts
4s 2200
3s 3350
4s 3300
3s 2200

I am wanting to getting speeds over 120 without mods. What motor should I get and use any of the above equipment? Should I get a whole new setup what should I get
Thanks

What C rating are those lipo's, if they're 20c then you're going to squeeze the life out of them

Get a Mega 16/25/2CE, which is 3, 4 and 5s capable (I've not run 5s myself tho). It's the cheapest Mega that's suitable for 130mph+ at around 74 euro's + postage. HET motor's work ok but I got through 2 HET's (3W) to 1 Mega (16/15/3) on a pylon racer.

If you want my (soap box) opinion on the 16/25/2CE pm me, or search this thread for some of my posts.

What would you recomend that is as cheap as that or cheaper?