Thread Tools
Old Dec 04, 2012, 12:26 AM
seeingeyegod is offline
Find More Posts by seeingeyegod
Registered User
seeingeyegod's Avatar
Quote:
Originally Posted by new user View Post
Yea, and I'm using a 72mhz hitec optic 6. This has never happened, I have flown it to around 1/4-1/3 of a mile and 100-200ft up, and around, over trees, power lines, etc and never once dropped the signal. I'm figuring its either a crystal connection or my ESC is acting up.
Sure it wasn't a loose solder joint in battery cable or ESC? Much more common to lose power/control that way than for a component to actually malfunction. Or were you using a seperate rx battery?
Sign up now
to remove ads between posts
Old Dec 04, 2012, 12:29 AM
new user is offline
Find More Posts by new user
OEF 10-11
new user's Avatar
Battery was fine, everything was working fine untill I swapped ESC. So I figure my problem lies there.
Old Dec 04, 2012, 01:22 PM
cwolfe is offline
Find More Posts by cwolfe
Registered User
cwolfe's Avatar
No wind, but pouring down rain.
Old Dec 04, 2012, 02:08 PM
fastfwd is offline
Find More Posts by fastfwd
Registered User
wind stopped for a bit late afternoon,took the Phoenix Evolution 2000 out for a maiden flight, click on quality go to HD then click full screen even then its small,
GOPR0063 (3 min 44 sec)


and this one was close to crash time ! Only difference is battery got moved and must have been to one side.
GOPR0064 (3 min 36 sec)
Old Dec 04, 2012, 02:51 PM
Felt_ripper 23 is offline
Find More Posts by Felt_ripper 23
Dude, get me some ice cream!
Felt_ripper 23's Avatar
Yay yesterday I flew the micro stryker on the ole' UM T28
Old Dec 04, 2012, 04:05 PM
tracknoob is offline
Find More Posts by tracknoob
Diverted by planks
tracknoob's Avatar
Heading out to fly da 3D Beast in 5...4....3...2...
Old Dec 04, 2012, 05:11 PM
Grazer is offline
Find More Posts by Grazer
Team Lumenier Pilot
Grazer's Avatar
Squeezed in a few night flights last night on my Radian and Quad.

It was a warm 30 degrees C and nil wind. Awesome!
Old Dec 04, 2012, 10:18 PM
new user is offline
Find More Posts by new user
OEF 10-11
new user's Avatar
I about cut my finger off again today. Lucky it wasn't as bad as last time, but dang it my engine runs.

I haven't flown in a few days. Time to get my behind in gear and get some stuff fixed
Old Dec 04, 2012, 11:00 PM
fastfwd is offline
Find More Posts by fastfwd
Registered User
Quote:
Originally Posted by new user View Post
I about cut my finger off again today. Lucky it wasn't as bad as last time, but dang it my engine runs.

I haven't flown in a few days. Time to get my behind in gear and get some stuff fixed
keep the fingers away from the spinning engine prop !
Old Dec 04, 2012, 11:31 PM
new user is offline
Find More Posts by new user
OEF 10-11
new user's Avatar
Yea this time it was me not paying attention. Limited space and I got lax around it.
Old Dec 05, 2012, 01:34 AM
Grazer is offline
Find More Posts by Grazer
Team Lumenier Pilot
Grazer's Avatar
Cut my foot on a carbon blade last night. Walked into my quad while it was sitting on my garage floor. And it wasn't even powered up and spinning!
Old Dec 05, 2012, 08:16 AM
whichwaysup is offline
Find More Posts by whichwaysup
when down=up, up=expensive
whichwaysup's Avatar
Had batteries charged up and planes packed up to hit the church parking lot this a.m. - but the weathermen were, well, highly paid for the value of their prediction.

Rain, Wind, you'd almost think it was winter time if it wasn't 56 degrees out there! Can't wait for Christmas - I happen to know (since I bought it) that there is a Blade Nano sitting under the Christmas tree. Assuming I can control it, it will make for a good indoor flier on days like this.
Old Dec 05, 2012, 01:03 PM
fastfwd is offline
Find More Posts by fastfwd
Registered User
Quote:
Originally Posted by new user View Post
Yea this time it was me not paying attention. Limited space and I got lax around it.
i spun up a folding blade while friend was holding plane on table.Blade hit friends leg no cuts but sure scraped off some skin ! was my fault for not looking where he was,and his fault for not paying attention,as he knew we was checking power . So yes it can and will happen !
Old Dec 05, 2012, 02:47 PM
Felt_ripper 23 is offline
Find More Posts by Felt_ripper 23
Dude, get me some ice cream!
Felt_ripper 23's Avatar
wind, wind, wind
Old Dec 05, 2012, 02:52 PM
fastfwd is offline
Find More Posts by fastfwd
Registered User
Quote:
Originally Posted by Felt_ripper 23 View Post
wind, wind, wind
wind,rain,hail,snow ! welcome to IDAHO !


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Hobby partz/Nitroplane going out of business ? Dennis Everett HobbyPartz.com 13 Nov 04, 2015 11:02 AM
Discussion I'm going out now, and may be gone for some time.... flyonline Slope 22 Oct 20, 2015 01:22 PM
Alert I'm going to be down and out for hopefully a .............. mtdoramike Trader Talk 15 Jan 09, 2009 06:11 PM
2.4 m Concorde 4 x BL EDF's build thread!!!!!!!!! its going to be BIG Paul DF jet man Electric Ducted Fan Jet Talk 70 Nov 14, 2008 01:12 AM
Whoops! Well, I'm going to be out of commmison for a while the_canuck Slope 74 Jan 20, 2006 04:59 PM