Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old May 23, 2003, 03:43 PM
I FO nut is offline
Find More Posts by I FO nut
Lazy sob
I FO nut's Avatar

will the mini twin from work with a 4 amp speed control?

Well whats the amp draw on this thing anyway?


Sign up now
to remove ads between posts
Old May 23, 2003, 04:46 PM
gobigdale is offline
Find More Posts by gobigdale
Time To Fly?
gobigdale's Avatar
I have been using a 2amp GWS with no problems. I dont fly full throttle for very long though

Old May 27, 2003, 04:22 AM
sam2000pres is offline
Find More Posts by sam2000pres
Registered User

Mini Twin

Using the stock EDP-50 motors and 3x3 props draws about ~2 amps or a little more, static, and about 17K rpm per motor.

I am sure it unloads quite a bit in flight. Using Qualcom Li-on batteries, two packs (one per motor) gives 20 min WOT flights.

Worst case, the motors overload the ESC and shut down. Most ESC's are rated at continuous current but can handle excess amp peak loads for a short duration okay.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Will servos from the 1980's work with todays RX? MikeSSS Radios 7 Mar 02, 2006 03:53 PM
building of my new mini speed wing from gazza2003au Foamies (Kits) 9 May 18, 2004 09:48 AM
Tough Choices: Dandy sports or mini twin from someone special Parkflyers 2 May 03, 2003 12:00 PM
My new Mini Twin from Acer Danny Troy Foamies (Kits) 25 Mar 27, 2003 11:12 PM
Anyone flying the Mini-ASW from CheeseWing Electric Sailplanes 1 Jan 03, 2002 01:08 AM