Shop our Airplanes Products Drone Products Sales
Thread Tools
May 18, 2003, 02:47 PM
E-Heli
Krona's Avatar

Cheap Logo 10 Parts ,Blade, Tail


I just wanted to let everyone know that I have tried these parts on my Logo 10 and they works just as good, if not better than original.

The Blades are 515mm Heli-Max ($17.99)
And the Tail parts are from Kyosho Concept 30 and Nexus 30 ($8.99)

With the 515mm blades my Logo flies just like the original 500mm blades but I get about 30sec longer hover and still have the same power.

The Tail parts are a little heavier than original, but much stronger. The tail fin will not flex like the original fin does. The helicopter flies the same with the new tail parts but I will probably not be able to break it again, they are very strong.

Anyway, I just wanted to let everyone know where to find some cheap replacement parts for the Logo. If I brake my Landing Bows I will try the Kyosho, they should work.

Heli-Max Blades
http://www2.towerhobbies.com/cgi-bin/WTI0001P?&I=LXM045

Kyosho Tail
White (no picture)
http://www2.towerhobbies.com/cgi-bin/WTI0001P?&I=LXW043
Blue (picture)
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXRB47

I also use Kyosho Tail Rotor Blades Nexus/Concept and they work just like the original tail rotor blades, but they are ($4.99)

Kyosho Tail Rotor Blades
http://www2.towerhobbies.com/cgi-bin/WTI0001P?&I=LXW050
Last edited by Krona; May 18, 2003 at 03:15 PM.
Sign up now
to remove ads between posts
May 18, 2003, 05:25 PM
Always right
Hovertime's Avatar
Thanks for the info, Krona!
May 18, 2003, 05:55 PM
E-Heli
Krona's Avatar
Here's a picture of the tail mounted.

This tail fits better than original, I think. Because it's harder so you can tighten it better and it's about 1/4 inch longer. So the tail blades won't hit the ground as easy.
May 18, 2003, 08:47 PM
Registered User
Valuable info!

Finding aftermarket Logo parts is tough.

Greg
Jun 09, 2003, 03:09 PM
www.dynamoelectrics.com
squelchF18's Avatar
How about tail rotor blades? Have you found any cheap replacements?
Thanks,
Chuck
Jun 09, 2003, 06:21 PM
www.dynamoelectrics.com
squelchF18's Avatar
How about Pinion gears? I am looking for a 12 or 11T pinion to try with my Mega Motor. Are these 48 pitch gears? Do you know of a cheap supplier to fit a 5mm shaft?
Chuck
Jun 10, 2003, 01:23 PM
E-Heli
Krona's Avatar
I don't know of any other pinion that will work.
I think the original Pich is 0.5 (Metric) or 64 (English).
Can anyone confirm this?

So any pinion with that pich should work.


Thread Tools