aleron conection help - RC Groups
Thread Tools
Jan 26, 2010, 08:49 PM
Registered User
cbear's Avatar
Discussion

aleron conection help


i need help conecting the alerons on my new dlg, i have a conector that came with the kit that has 4 pins, i want to have alerons and flaps- flaperons and be able to reflex the wing up to leave the down air , can someone post a pic of how this works with one servo in each wing,4 wires from the wing going to the reciever , thanks
Sign up now
to remove ads between posts
Jan 26, 2010, 09:34 PM
Steve
if no one has a diagram I,ll send a pic of a complete harness
Jan 26, 2010, 09:36 PM
Registered User
soarluck's Avatar
Simple really ....look at it this way ..three wires on each servo two are to power the servo [black/red] the colour wire is the signal wire ..treat the signal wire as the wire that gets the commands from the receiver

the power wires /black/red can be connected together from both servo`s then you only need 4 wires from there [2 signals and a black and a white]
If you want to you could run all servos off just one plug on the rx but the signal wires need the proper port
SL
Jan 26, 2010, 09:49 PM
Registered User
cbear's Avatar
got it thanks guys
Jan 26, 2010, 09:52 PM
Registered User
soarluck said it right, I just figured I'd paint something up quick.

Jan 26, 2010, 09:54 PM
Registered User
p.s. I use a bigger servo in my oppisite from the peg wing for balance purposes =P
Jan 26, 2010, 10:03 PM
Steve
its a little fuzzy
Jan 27, 2010, 09:23 AM
Chuck 'Em and Chase 'Em
Fly2High's Avatar
Aradhana has the connector diagramed and photographed here superbly. All his instructions are top notch

http://www.rcbuilder.com/lh_guide/ma...er_harness.htm

I think this will answer all your questions.

Good Luck

Frank
Jan 27, 2010, 10:33 AM
Guz
Guz
Gutless wonder
Guz's Avatar
Basic schematic



Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Aleron throw differential bondohead Electric Plane Talk 16 Jan 04, 2010 09:02 PM
Discussion Conection break down ? Palo Gabris Batteries and Chargers 0 Oct 03, 2009 06:04 PM
Question removing a cig lighter conection lilpip Batteries and Chargers 2 Sep 25, 2006 07:23 PM
Stuttering starts = poor conection Larry3215 Power Systems 0 Jun 24, 2004 12:36 AM
Urgent!!!! FMA mini 20 ESC conection to the motor spy0o7 Power Systems 5 Jul 08, 2001 07:13 AM